Research article · Feb 2014
Research articlePublished Dec 2014
Single Phase Power Factor Correction Based on Averaged Current Mode Controlled Boost Converter
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
The conventional full-wave diode bridge rectifier with an output capacitor filter produces current spikes in the supply, thus lowering the power factor and distorting the waveform. An ideal rectifier presents an effective resistive load (Emulated resistance) to the AC power line; hence, if the supplied AC voltage is sinusoidal, then the current drawn by the rectifier is also sinusoidal and is in phase with the voltage. Converters that approximate the properties of the ideal rectifier are sometimes called power factor corrected, because their input power factor is nearly unity. The boost converter, as well as a variety of other converters, can be controlled such that a near ideal rectifier system is obtained. This is accomplished by control of a high-frequency switching converter, such that the ac line current waveform follows the applied ac line voltage. The boost converter is operated in Continuous Conduction Mode (CCM), and controlled by Average Current Mode Control (ACMC). The system contains multi-loop control strategy and a feed-forward loop in order to get power factor near unity with constant output power. There are a variety of Power Factor Correction (PFC) chips available in the market, one being the UC3854, can be operated in Average Current Mode Control. The simulation of a 250W, AC – DC rectified system with Unity Power Factor at the input using UC3854 was done in PSIM Power Electronics simulation software and results were obtained.
Keywords
Subjects
EngineeringAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Research article · Apr 2015
Single Phase AC-DC Converter Employing Power Factor Correction with High Frequency Isolation Using Buck-Boost PWM Converter
Research article · Mar 2014
Application of Digital Slope Compensation in Peak Current Mode Control of Buck- Boost Converter
Research article · Jan 2015
Comparative Study of Power Factor Correction and THD Minimization Using Boost Converter and Interleaved Boost Converter Using Pi Controller
Research article · 21 Aug 2015
Design of Boost Converter of Sliding Mode Control Powered by PV Array
More from this journal
The newest in International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering.
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalInternational Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering
- SubjectEngineering
- BylineArticles whose byline prints “Blessen Antony Francis”
- BylineArticles whose byline prints “Bos Mathew Jos”
- BylineArticles whose byline prints “Babu Thomas”
