Scholars Central

Conference abstractPublished 23 Nov 2017

Bed Adjustment while Treating Patients

Authors: Deborah Alperovitch-Najenson PT, Shani Milyoner BPT, Dafna Horesh-Sztulman BPT, Omer Weissberger BPT, David Ezra PhD

Department of Physical Therapy, Recanati School for Community Health Professions, Faculty of Health Sciences, Ben-Gurion University of the Negev, Beer Sheva, Israel The Academic College Tel Aviv-Jaffo, Jaffo, Israel Sackler Faculty of Medicine, Department of Environmental and Occupational Health, Tel Aviv University, Tel Aviv, Israel

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Background: Health care providers, especially those with direct patient contact, are one of the occupational groups most injured by WRMD. A combination of lifting heavy loads with awkward postures is most hazardous, especially for low back pain. Adjusting the bed, during performance of manual tasks, creates a more erect thus safer for the therapist's lumbar spine. Objectives: To compare adjusted bed height between two passive manual tasks and to find an optimal topographic location to rely on when adjusting bed height. Design: Cross-sectional study. Methods: Eighty physical therapy students performed two specific passive movements: shoulder flexion (SF) and straight leg raise of thigh (SLR), each task executed either on a standard bed and an adjustable one. The lumbar angle was measured at the beginning and at the end of each task using a smartphone, which served as an inclinometer. The rate of perceived exertion (RPE) was measured after each task. Distances from anatomical points on the hand and pelvis to the floor were measured. Results: The mean bed height for SF was significantly higher than for the SLR. The third knuckle hand technique and the radial styloid process of the wrist (RSP) were established as the most valuable anthropometric points to rely on when adjusting the bed height. Both tasks had higher RPE rates and the subjects experienced more of a bent back bent when performing the tasks on a standard bed height compared to an adjustable one. Conclusions: Each manual task requires its own bed height adjustment. Moreover, it is essential that any manual task entailing lifting appears to place the therapist at risk for lower back pain as a result of awkward postures. The third knuckle and RSP are recommended as reference points when adjusting the bed height.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Similar by topic

More from this journal

The newest in Occupational Medicine & Health Affairs.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalOccupational Medicine & Health Affairs
  • SubjectPublic Health & Epidemiology
  • BylineArticles whose byline prints “Deborah Alperovitch-Najenson PT”
  • BylineArticles whose byline prints “Shani Milyoner BPT”
  • BylineArticles whose byline prints “Dafna Horesh-Sztulman BPT”
  • BylineArticles whose byline prints “Omer Weissberger BPT”
  • BylineArticles whose byline prints “David Ezra PhD”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels