Scholars Central

Conference abstractPublished 24 Jul 2017

Graphene-based material for oil spill removal

Authors: Annalisa Pola

Directa Plus SpA, Italy

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Oil spill events required efficient and rapid response by authorities and operating staff. The emergency management is not simple and usually is affected by a large consumption of materials and high operative costs. The optimization of the adsorbents is a starting point to reduce these costs. In this study, a graphene-based material (called Grafysorber, produced by Directa Plus S.p.A) was used inside adsorbent devices (barriers and pillows) to treat waters containing an oily separated phase. Grafysorber is a super-expanded graphite with a production apparent density of about 2.5 g/L. Three different kind of oils were tested: kerosene, diesel fuel and crude oil, to understand if there is a relationship between viscosity and sorption capacity. In addition, reusability of each device was evaluated. Little pillows of about 10*10 cm were used for adsorption tests. Results showed that the greater is the viscosity, the greater is the amount of oil sorbed; 50.8 g/g for kerosene, 76.5 g/g for diesel fuel, 81.78 g/g for crude oil. Grafysorber pillows can be reused, after simple squeezing, for about 4-5 times. A progressive decrease of adsorption capacity was detected. Polypropylene, the standard adsorbent material used worldwide in case of water oil spill clean-up activities, showed a sorption capacity at least six times lower than Grafysorber®. The effect of the waves was considered, using diesel fuel, in a 1*5 meters tank, and small adsorbent barriers (7.5 cm diameter and 50 cm length). Water motion caused an increase in the saturation’s speed but also an increase of retained water both for Grafysorber and for Polypropylene barriers. A dropping phase of 5 min is necessary for Grafysorber and polypropylene devices to favor the water expulsion from the adsorbent device. Anyway, it has been demonstrated that Grafysorber retains on average the 50% less of water than polypropylene.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • SubjectMaterials Science
  • SubjectNanotechnology
  • SubjectPetroleum & Mining
  • BylineArticles whose byline prints “Annalisa Pola”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels