Scholars Central

Research articlePublished Dec 2014

Thermal Analysis of Steam Ejector Using CFD

Authors: T.Aravind, Dr P Ravinder Reddy, S S Baserkoed

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

This work focuses on the numerical simulation of the working of a steam ejector in order improve the performance. Computational Fluid Dynamics (CFD) was employed for the numerical simulation. In this work the effect of operating conditions on the performance of the steam ejector operating in conjunction with an ejector refrigeration cycle was considered along with the effect of geometry parameter. The model and meshing is done with GAMBIT and FLUENT solver is used for the analysis. The simulations are performed with different operating conditions and geometries. The entrainment ratio is found to increase with the decrease of boiler saturation temperature for the same condition of superheat, evaporator temperature and condenser pressure. The entrainment ratio is also found to increase with increase of evaporator temperature keeping the boiler temperature and condenser pressure constant. The entrainment ratio does not vary much with the condenser pressure until the critical condenser pressure. It is also found that the entrainment ratio increases with decrease of throat diameter of the primary nozzle. The increase of entrainment ratio can be found out from the moving downwards of the effective position. But, a larger mass of secondary fluid causes the momentum of the mixed stream to decrease. The decrease of momentum can be determined from the moving upstream of the shocking position. The movement of shocking position upstream can cause the ejector to operate at a lower critical condenser pressure.

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Similar by topic

More from this journal

The newest in International Journal of Innovative Research in Science, Engineering and Technology.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalInternational Journal of Innovative Research in Science, Engineering and Technology
  • SubjectEngineering
  • BylineArticles whose byline prints “T.Aravind”
  • BylineArticles whose byline prints “Dr P Ravinder Reddy”
  • BylineArticles whose byline prints “S S Baserkoed”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels