Conference abstract · 7 Nov 2016
Conference abstractPublished 7 Nov 2016
Optical and Electrical properties of Bacteria were Based Bio-detector for Heavy Metals (CdCl2 and NiCl2) Pollutants
University of Basra, Iraq
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Environmental pollution can be defined as any discharge of material or energy into water, land and air, that causes adverse changes to the earth's ecological balance, or that lowers the quality of life. One of the most danger contaminations are the heavy metals, which are commonly referred to as trace metals; many trace metals are highly toxic to humans (e.g. Hg, Pb, Cd, Ni, As, Sn) and other living organisms in the environment. There are many techniques used for detection of heavy metals, for example; AAS, ICP-MS and Chromatography. In this project, the bio-cell sensor that included the microorganisms bacteria ( E. coli and D. radiodurans) was employed for detection of heavy metals, which is considered to be a cheap (cost effective), simple (easy to use), powerless (portable) and sensitive technique. Characterization of bacteria samples were carried out using a variety of experimental techniques, i.e. optical methods including optical density measurements, UV-Vis spectrophotometer, fluorescent microscopy and spectroscopy for studying light scattering in bacteria samples and electrical methods both DC and AC are used. The results of the optical methods appeared to be completely different of bacteria response and did not correlate with the (live/dead) bacteria ratio, which are due to the effect of (Cd2+, Ni2+) ions on light scattering. The electrical technique was used to study the effect of heavy metals (CaCl2 and CaCl2) on bacteria. The effect of metal salt appeared to be comparable on both E. coli and D. radiodurans bacteria. AC and DC properties of electrochemical solutions that contained E. coli and D. radiodurans bacteria were studied, and the results were compared to and normalized to the results of samples not mixed with metals. Comparative figures can be used to estimate metal concentration and the effect of metal on bacteria.
Subjects
Energy & PowerMicrobiologyAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Conference abstract · 22 Sep 2016
Optical and electrical properties of bacteria were based on bio-detector for heavy metals (CdCl2 and NiCl2) pollutants
Conference abstract · 22 Sep 2016
Optical and electrical properties of bacteria were based on bio-detector for heavy metals (CdCl2 and NiCl2) pollutants
Conference abstract
Assessment of metal pollutants and physico-chemical parameters of river water at Sarvamangla Nagar (Korba), Chhattisgarh and identification of potential bacteria for bio-remediating heavy metals
Perspective · 30 Dec 2022
Engineering the Electrical and Optical Properties of Graphene Oxide via Simultaneous Alkali Metal Doping and Thermal Annealing
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- SubjectEnergy & Power
- SubjectMicrobiology
- BylineArticles whose byline prints “Maytham Abdala Ali Al-Shanawa”
