Conference abstractPublished 20 Mar 2017
Fabrication of hierarchical structures using electrospinning for dry adhesive applications
Singapore University of Technology and Design, Singapore
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
In this study, hierarchical structures for dry-adhesive applications were fabricated using electrospinning combined with template wetting method. Briefly, in the first step, electrospinning technique was used to produce micron sized fibers which were directly deposited on porous anodized aluminum oxide (AAO) template. Following this step, the setup consisting of the AAO template along with the fibers was heated above the glass transition temperature of polymer. This enabled the flow of polymer within the porous channels and resulted in the growth of nanometer sized pillars on the surface of the fibers. Based on this fabrication technique, we produced hierarchical structures using two different polymeric systems, viz. poly(methyl methacrylate) (PMMA) and poly(vinylidene fluoride) (PVDF). A representative scanning electron microscopy (SEM) image of the fibers is shown in Figure-1. The SEM image shows that this approach led to the growth of sub-nano structures on the surface of the fibers. These samples were used to investigate the normal as well as shear adhesion behavior of hierarchical structures. The normal adhesion was characterized using a nanoindenter. A flat circular indenter tip (diameter=10 µm) was used to indent the surface of the samples and then retracted back. The pull-off required to separate the indenter tip from the samples was recorded. This pull-off force gave an indication of its normal adhesion. Similarly, the samples were finger pressed onto sandpaper with varying degree of roughness. The samples were then pulled in shear and the shear adhesion force was characterized. Fibers without any surface structures were also tested and their adhesion behavior was compared with that of hierarchical samples. The samples with surface nanostructures exhibited increased pull-off force compared to neat control samples due to its improved van der Waals interactions.
Ask about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- BylineArticles whose byline prints “Avinash Baji”
