Scholars Central

Conference abstractPublished 2018

Correlation of a phase change correction and surface roughness

Authors: Pawat Phuaknoi, Kitti Wirotrattanaphaphisan, Namfon Pafon, Samana Piengbangyang, Jedsada Wongsaroj, Jariya Buajarern

King Mongkuts University of Technology North Bangkok, Thiland Rajamangala University of Technology Thanyaburi, Thiland National Institute of Metrology, Thailand

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

The interferometric phase correction has a fairly high uncertainty because of the difficulty of the measurements. In addition, phase measurement is much too difficult to make on each block and so only a few blocks from each manufacturer are tested and the average of these measurements are assigned to all blocks from the same manufacturer. Estimated uncertainty in the phase correction is typically around 6 nm. There have been a number of attempts to measure phase by other means such as integrating sphere, but none have been particularly successful due to complexity of the measuring process. However, gauge blocks from the same manufacturer but with different materials, or the same material from different manufacturers, generally have different phases. One way to reduce phase problems is to restrict your master blocks to one manufacturer and one material. Another way to reduce effects of phase change is to use gauge blocks and platens of the same material and manufacturer. While this seems simple in principle, it is not as easy in practice. Most manufacturers of gauge blocks do not make platens. Here we present an alternative method to determine phase correction of an individual gauge block by measuring roughness of the gauge block’s face. By applying this technique, phase correction of each block can be determined with a simple measurement. Figure 1 illustrates a good agreement between the phase correction obtained from the stacking method and those obtained from the roughness measurement. The advantage of this method is that not only the procedure is simple but the experience of the operator does not have impact of the accuracy of measurement.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Research Journal of Optics and Photonics.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalResearch Journal of Optics and Photonics
  • SubjectPhysics & Astronomy
  • BylineArticles whose byline prints “Pawat Phuaknoi”
  • BylineArticles whose byline prints “Kitti Wirotrattanaphaphisan”
  • BylineArticles whose byline prints “Namfon Pafon”
  • BylineArticles whose byline prints “Samana Piengbangyang”
  • BylineArticles whose byline prints “Jedsada Wongsaroj”
  • BylineArticles whose byline prints “Jariya Buajarern”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels