Scholars Central

Conference abstractPublished 2 Jul 2018

Low-cycle-fatigue failures of solder material in electronic products: Analytical modeling enables to explain, predict and possibly prevent them

Authors: Ephraim Suhir, Johann Nicolics

Portland State University, USA TU Wien, Austria

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

This presentation is based mostly on the authorâÂ?Â?s recent research and addresses the application of analytical (âÂ?Â?mathematicalâÂ?) predictive modeling to understand the physics and mechanics of the behavior and performance of solder materials employed in microelectronic systems. The emphasis is on the design for reliability and, first of all, on the prediction of the thermal stresses and strains in solder joint interconnections. While the overwhelming majority of the numerous studies addressing solder materials are either experimental or based on finite-element-analyses (FEA), the approach considered in this presentation uses analytical predictive modeling techniques to predict stresses and strains and suggest methods for their minimization. Both ball-grid-array (BGA) and column-grid-array (CGA) designs for the second level of interconnections are addressed, and the attributes of flip-chip designs are indicated and discussed. The developed models suggest the most effective design-for-reliability methodologies to relieve stresses in strains in solder joints, and to determine, at the design stage, if inelastic strains in the solder material could occur and be avoided. If not, these models are able to predict the sizes of the inelastic zones at the end portions of the assemblies. The following major efforts are addressed: Analytical modeling, its significance, role, attributes and challenges; Method of interfacial compliance (MIC); Inelastic strains in, and low cycle fatigue of, solder materials; Elevated stand-off heights and application of inhomogeneous solder systems for relieving stress and strain in solder materials; Attributes of solder joints in flip-chip designs; Board level dynamic testing of BGA vs. CGA solder joint interconnections; Novel experimental method of solder material characterization; Accelerated testing of solder joint interconnections: failure-oriented accelerated testing (FOAT) as a possible extension of highly-accelerated-life-testing (HALT); Incentive for mechanical pre-stressing of accelerated test specimens subjected to temperature cycling and; Incentive for using a low-temperature/random-vibrations bias as effective substitute for temperature-cycling tests of solder joint interconnections. It is concluded that all the three approaches of the applied science and engineeringâÂ?Â?experimental, computer-aided and analyticalâÂ?Â?are equally important to make a viable device into a reliable product, and that analytical modeling can be effectively used to predict and possibly prevent failures of solder joints in electronic products.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Similar by topic

More from this journal

The newest in Journal of Material Sciences & Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Ephraim Suhir”
  • BylineArticles whose byline prints “Johann Nicolics”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels