Review article · 3 Jan 2023
Conference abstractPublished 2 Jul 2018
A newly thermal convective angular accelerometer on polyimide substrate
Chung-Hua UniversityÃ?¸Taiwan
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
The key points of this work are as follows. (1) To make a thermal convective angular accelerometer directly on a flexible substrate (e.g. an engineering PI tape) so the new design can reduce the energy loss of heater to the substrate. Since the thermal conductivity of polyimide is 0.06-0.0017 W/(cm-K), it is about twenty-fifth that of the silicon (1.48 W/(cm-K)), thus these devices can preserve much energy than the previous ones without wasting to the environments. (2) To make both heater and thermal sensors directly on the PI substrate without floating over a grooved cavity on silicon wafer, so the device is more reliable and cheap. (3) one could increase the sensitivities by making nonfloating accelerometers on flexible substrates. Moreover, the thermal sensors were made to stack on a layer of aluminum nitride (with thickness 1 mm). (4) The chamber was filled with an inert gas (xenon) instead of carbon dioxide or air, thus one could completely avoid the oxidation effect of components, and increase both reliability and life cycle of the device. (5) The traditional rectangular chamber was replaced by a hemicylindrical one, such that the sensitivity could be improved. Practical device was made to prove the ideas of the new design. Finally, the device was put on a flight table for testing, a methodology to derive the formular between the temperature difference of the thermistors and the angular acceleration was made, and the sensitivity of the proposed angular accelerometer was 1.828r/s2/K.
Subjects
EngineeringMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Conference abstract · 20 Jun 2018
Fabrication of high thermal conductive diamond/copper composites and their joining with substrates
Conference abstract · 6 Oct 2014
Influence of substrate on the efficiency of aluminide coatings and thermal barrier coatings
Research article · 2014
Effect of substrate temperature on structural and optical properties of thermally evaporated thin films of F16CuPc
Conference abstract · 3 Dec 2018
Numerical modeling for episodic thermal convection in enceladus ice shell
More from this journal
The newest in Journal of Material Sciences & Engineering.
Article · 19 Feb 2026
Progress and Challenges in AlGaN/GaN HEMT-Based Bio sensing
Perspective · 29 Dec 2025
Nanostructured Thin Films: Advancing Next-Generation Electronics
Brief report · 29 Dec 2025
Microstructural Defects: Impact on Material Properties and Performance
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of Material Sciences & Engineering
- SubjectEngineering
- SubjectMaterials Science
- BylineArticles whose byline prints “Jium-Ming Lin”
- BylineArticles whose byline prints “Shu-Long Wu”
- BylineArticles whose byline prints “Cheng-Hung Lin”

