Scholars Central

Conference abstractPublished 19 Feb 2018

n-type doping of diamond for electronics

Authors: Marie-Amandine Pinault-Thaury

Scientific Research National Center, France

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Diamond offers very interesting potential applications for high temperature, high frequency and high power electronics. In order to use it as an electronic grade material, the controls of its quality and its doping are necessary. As most of wide band-gap semiconductors, diamond suffers from an asymmetry in the control of its doping. While the p-type conductivity is easily achieved by using boron impurities, the n-type doping is still an issue for the development of bipolar electronics based on diamond. As electronic applications need high material chemical purity, the microwave plasma assisted chemical vapor deposition (MPCVD) is currently the most used growth techniques for diamond. For n-type doping, the range of impurities that should fit into the diamond lattice is limited and the equilibrium solubility of dopants in bulk diamond is often low. Despite a covalent radius ~1.4 times bigger than carbon and a donor level relatively deep (EC=0.6eV), the highest n-type conductivities have been achieved with incorporation of phosphorus impurities during the homoepitaxial growth. This impurity has been reproducibly incorporated into (111) monocrystalline diamond by using different phosphorus precursors (gaseous or liquid) during MPCVD diamond growth up to a few 1020 P/cm3. However to incorporate phosphorus in donor sites is more difficult (100) orientation that is preferential for electronics. In this review, the difficulties inherent to the n-type doping of diamond will be presented. The different donors in diamond will be reviewed as well as the doping methods. The properties of n-type diamond grown in the GEMaC laboratory with phosphorus doping will be shown. The results achieved both on the (111) and the (100) orientated-substrates used for the homoepitaxy will be given. The incorporation in substitutional site and the high compensation level by residual impurities and defects will be discussed.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Similar by topic

More from this journal

The newest in Journal of Material Sciences & Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Marie-Amandine Pinault-Thaury”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels