Scholars Central

Conference abstractPublished 28 Sep 2017

Development of multispeed ratio drivetrains for electric vehicles

Authors: Benoit Boulet

McGill University, Canada

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

As the story goes, Tesla tried to develop a two-speed ratio transmission for its Roadster around 2007. But after a series of failures that delayed production and almost tanked the company, a decision was made to use a single-speed-ratio transmission. Tesla’s ensued success with single-speed-ratio drivetrains, also adopted by other electric car manufacturers, leads to the question: Is there a need for multispeed drivetrains in electric vehicles? If so, for what class of vehicles? Is it economical? Our research has shown that the electrification of vehicles larger than class 3 is where multispeed transmissions may be considered, but perhaps not currently for smaller vehicles, apart for high-performance race cars or GTs. The cost question, while crucial in the automotive industry, is very difficult to settle for a new electric powertrain design because the production volumes are still very small. Given a set of performance specs for the vehicle, and assuming peak power is not the main constraint, is it better to choose a larger motor and power inverter for a single-speed-ratio architecture, or to select a smaller inverter and motor coupled to a two-speed transmission? To help resolve this question, we studied the cost-reliability-performance of EV powertrains to come up with formulas that could be used in a design optimization trading off the cost of the powertrain versus its performance and reliability. On the performance side, we designed a two-speed clutch-less automated manual transmission (AMT) and tested it on a compact electric car for dynamometer and road testing. Then, we studied friction in the synchromesh of an AMT to design a feedback controller for the synchronizer’s cone clutch. This was done to control friction at a favourable location in the mixed lubrication regime on the Stribeck curve that maximizes torque transfer while minimizing wear during gear shifts. A new type of two-speed transmission was also designed to alleviate the torque dip of the AMT while avoiding the use of a clutch. The resulting patented Dual Brake Transmission (DBT) has shown promise for high efficiency, high torque and smooth operation of EVs.

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Advances in Automobile Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalAdvances in Automobile Engineering
  • SubjectEngineering
  • BylineArticles whose byline prints “Benoit Boulet”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels