Scholars Central

Conference abstractPublished 9 Mar 2022

Analytical (and#34;mathematicaland#34;) modeling enables explaining some critical paradoxical situations in electronic and photonic materials behaviors

Authors: Ephraim Suhir

Portland State University, USA

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Merits, attributes and challenges associated with the application of analytical predictive modeling in electronics and photonics materials science are addressed, based mostly on the author’s research during his tenure with Bell Labs, UC-Santa Cruz, Portland State University, and small business innovative research (SBIR) ERS Co., USA. The emphasis is on practically important, yet paradoxical, i.e., intuitively non-obvious, material behaviors. The addressed problems include, but are not limited to the answers to the following questions: 1) why do the interfacial thermal stresses concentrate at the assembly ends and, for large size and/ or stiff assemblies, do not increase with the further increase in the assembly size? 2) Could thermostatic compensation in temperature sensitive optical devices be achieved by employing regular materials? 3) Is it possible to design, fabricate and operate a bow-free electronic assembly? 4) What are the relative levels of thermal and lattice mismatch stresses in semiconductor crystal grown assemblies, and could one grow dislocation free lattice-mismatch assemblies? 5) Could shock tests adequately mimic drop test conditions? 6) Is the maximum acceleration an adequate criterion of the dynamic strength of an electronic product? 7) Could a static load be more damaging than a dynamic one? 8) Could a closed-form solution be obtained for highly nonlinear vibrations? 9) How significant is the role of higher modes of the shock induced PCB vibrations? 10) Could inelastic strains in solder joint interconnections be avoided? 11) Stretchable electronics: does one really need good thermal expansion (contraction) match between the die and the carrier? 12) Could the threshold of the added transmission losses be predicted based on mechanical considerations? 13) Is there an incentive for pre-stressing accelerated test specimens? 14) Could thinner and longer legs in a thermoelectric module design relieve stress? It is concluded that analytical modeling should always complement computer simulation in every materials science undertaking of importance. These two major modeling tools are based on different assumptions and use different calculation techniques, and if the computed data obtained using these tools are in agreement, and then there is a good reason to believe that these data are accurate and trustworthy.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Similar by topic

More from this journal

The newest in Journal of Material Sciences & Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Ephraim Suhir”

For authors and organisers

Publish, present and keep up with your field

Find the right journal for your paper and submit your manuscript.

Photo: Pexels