time load control problematic. To better simulate in-vivo multi-directional load conditions we report on development of a Cartesian load controlled testing system (CLTS) with coordinated real-time load
presented and analyzed. These test facilities differ by the geometry and materials used to simulate FA?s. Some of tests perform the ballooning and depressurization of fuel rods during ... liquid subcooling to model FA…
even non-structural data, such as 1) the modeling and simulation of the heterogeneous data at a systems network level 2) the collection of paired biological and personalized medical data
model for the simulation of steady viscous and compressible flows for turbo machinery. A mechanical compressor that will be implemented in an MED-MVC desalination system was numerically investigated. This…
linear systems, thus, computationally it goes very fast and can be applied to several large sets of data and yield estimated models very quickly. The estimated models are simulated
data collected during the period from 1923 up to 2001 were used in this simulation. The bathymetry of the area was obtained from the National Geophysical Data Center (NGDC) (ETOPO2 ... RSOW). Over the sill at Bab el…
attempt is made to model a conventional solar distillation system and comparing the experimental results with simulated model. Solar distillation is an old process, but cost wise and for domestic
training among workers. Quantitative analysis of the ergonomic interventions by digital human modelling and simulation (DHMS) are done using CATIA V5 software. It helps to regenerate the environment without affecting…
heat exchanger is compared with classical PID control. System behaviors were defined by Lagrange formulation and MATLAB computer simulations. The simulation results confirm that interval type2 fuzzy
coefficient of design system and real system. Hybrid algorithm is the hot issue in Computational Intelligence (CI) study. From in-depth discussion on Simulation Mechanism Based (SMB) classification method
logic control. The motor was modelled and converted to a subsystem in SIMULINK. The simulation development of the PID controller with the mathematical model of DC motor is done using ... fuzzy logic controller is…
area power system is used as the case study. Computer simulations for the test system subjected to transient disturbances i.e. a three phase fault, were carried out and the results ... system damping when compared to a…
Arrival (DOA) estimation algorithms are used to locate the desired signal in smart antenna system. This paper presents an effective spatial differencing method for DOA estimation of multiple uncorrelated ... technique…
Error Rate (BER) performance of 2-by-2 spatially multiplexed MIMO system incorporates with transmit diversity such as Space Time Block Code (STBC) and Space Frequency Block Code (SFBC ... decomposition under BPSK, QPSK…
different speed levels. The fan regulator has been simulated and experimentally tested. It is found that the system works satisfactorily and the experimental results are almost same
wavelet packets and used as the modulation waveforms in a multicarrier CDMA system. The WP-MC-CDMA shows their superiority over conventional MC-CDMA in terms of bit error rate ... present the comparison all three…
high power applications. Power converters overcomes the main issues associated with power delivering system such as load variations, high or low voltages etc. This paper studies and compares the merits ... classical…
maximum benefit in terms of power transfer capability and stability of the system. All the simulations for the above work have been carried out using MATLAB /SIMULINK software
This paper presents the virtual environment implementation for project simulation and conception of supervision and control systems for mobile robots, which are capable of operating and adapting in different…
obtain the multiple outputs of DC-DC converter with a coupled inductor. The proposed system consists of single input of low voltage level, which can be boost into two different ... reduce the rise time and steady state…
scenario due to their ability to produce clean, reliable, useful power. Grid connected Photovoltaic system requires conversion from DC to AC to harness the useful energy produced. A Photovoltaic inverter ... power plant…
high step-up dc–dc converter for a distributed generation system is proposed in this paper. The concept is composed of two capacitors, two diodes, and one coupled inductor ... obtain 400v output voltage and 400w output…
present the reduction of losses and maintain voltage profile constant in Distribution system by implementing HVDS over LVDS. The Overall power losses are mainly classified into Transmission losses, Distribution losses…
system along with control system for speed and current has been presented using MATLAB / SIMULINK. In order to evaluate the model, various cases of simulation studies are carried out. Test
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.