times: 1, 20, 50, 100 and 200 hours. It was possible to observe the microstructural changes produced in the steel through the corrosive environments, as well as changes in physical ... material a characteristic…
clad layers was calculated. The surface morphology and the composition of the coatings were characterized by Scanning Electron Microscopy (SEM) and Energy Dispersive Spectroscopy (EDX), respectively. The results show…
reactor, under conditions of cyclic steam stimulation (240 - 300 °C, 700-1400 psi). The characterization of the samples obtained was carried out by MALDI-TOF MS (matrix-assisted laser desorption ... Nuclear Magnetic…
fluid) up to 7 and 14 days at 37.4o C. Same set of characterizing parameters were studied subsequently. It was found that non-cytotoxic crystalline HAp with ... substrate with pores around 300-500 nm throughout and with…
were synthesized by co-precipitation method, after that they were dispersed in PVP matrix. Microstructure, morphology and average crystalline size of PVP capped ZnS:Mn (ZnS:Mn/PVP) nanoparticles were ... nanoparticles…
micro structural parameters (grains size, densification, porosity, intergranular phase). These ceramic materials were then characterized from the mechanical point of view (hardness, toughness, friction and wear) and…
micro structural parameters (grains size, densification, porosity, intergranular phase). These ceramic materials were then characterized from the mechanical point of view (hardness, toughness, friction and wear) and…
bread evolution with time with emphasis on fat crystallization and starch retrogradation. After characterization of the original bread, fat functionality was studied. The formulation, fat type and presence ... over 8…
work examines the roles of the composition of the collagen-based scaffolds on the microstructures, mechanical properties, and bioactivities. Scaffolds (with up to 80% elastin or 50% chondroitin-4-sulfate ... prepared…
studied morphology dependent gas sensing behavior to NOx gas at low temperature. The characterizations of the as-prepared samples were done in details by X-ray diffraction (XRD), scanning electron ... morphology of the…
Electron Microscopy (SEM) is a powerful imaging technique used to examine the surface morphology, microstructure, and composition of materials at high magnification and resolution. By scanning a focused electron beam…
environments may lead to premature loss of mechanical integrity and cytotoxic effects. Here we characterized the corrosion behavior and mechanical properties of a novel magnesium-zinc alloy ... homogenizing treatment…
environments may lead to premature loss of mechanical integrity and cytotoxic effects. Here we characterized the corrosion behavior and mechanical properties of a novel magnesium-zinc alloy ... homogenizing treatment…
environments may lead to premature loss of mechanical integrity and cytotoxic effects. Here we characterized the corrosion behavior and mechanical properties of a novel magnesium-zinc alloy ... homogenizing treatment…
followed by hot extrusion. The influence of ceramic reinforcement nanoparticles (B4C) on the physical, microstructural, mechanical and thermal characteristics of the extruded Al–B4C nanocomposites was investigated. The…
field of nanomaterials for environmental protection. Given the hexagonal mesoporous silica arrangement, characterized by a high specific surface, as well as very well defined shapes and dimensions of its pores ... this…
widely used in the design of restoration mortars; the improvement and upgrading of their microstructures, texture and the physical, mechanical and dynamic properties like dynamic Young's modulus and wave…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.