initialized after being divided into two parts, and simulated in the environment of MATLAB/Simulink. The comparison of the indexes of MPPT performance and the waveform of output verifies that
control theory. Simulation on the nonlinear four-wheel steering tractor-semitrailer dynamic model in Matlab/Simulink software environment was described. The Simulation results show that the four-wheel steering direct
types of converters are compared for various duty cycles. Simulation is carried out in MATLAB/SIMULINK. The results are discussed and verified with the theoretical values
automatically connect you to the closest available WiMAX antenna. This project was built in Matlab Simulink and various antenna configurations was designed and then checked for its performance and compared
method to control speed of DC motor using analog Controller. With the availability of MATLAB/SIMULINK, Fuzzy Controller for comprehensive study of modeling analysis and speed control design methods
FoPSS yields satisfactory results when there is drastic load change in long transmission lines. MATLAB/Simulink simulation is used to show the improvement of system’s performance when FoPSS
control design methodology for each component of the proposed system is also described. A MATLAB/Simulink simulation model is developed for the SOFC DG system by combining the individual component
phase proposed inverter with multistring boost converter photo-voltaic system is carried out using MATLAB-Simulink software and the result shows the viability of the proposed topology
each sample period. The performance of this method is demonstrated by simulation using Matlab/ Simulink software. Simulation results presented in this paper show the torque, flux linkage and stator current
Active Power Filter) does not arise. The system is modeled and analysed using MATLAB Simulink. The new system will result in high reliability, low cost and better utilization of resources
outer speed control loop is analysed. The scheme is simulated in MATLAB/SIMULINK and the performance of FLC based scheme is compared with those of PI controller based scheme
simplest method called incremental conductance method is utilized to track maximum power point. Matlab/Simulink model is used to verify the operation and performance of this converter. Simulation results obtained
rejects input voltage perturbations.Simualation of the circuit employing One Cycle Control is done in MATLAB/SIMULINK .A prototype of voltage doubler buck converter generating a dc voltage of 12V operating
mathematical model with trapezoidal back emf is proposed with the help of MATLAB/Simulink software. The motor is simulated through mathematical modeling and switching to inverter is fed according
supply. A mathematical model for a three phase induction motor is developed in matlab/simulink and observed the effectiveness of the system in the elimination of torque pulsations. Hardware
sector identification and switching vector determination. The validation of the algorithm through simulations in MATLAB/SIMULINK has been carried out for two legged 3-level and 5-level inverter configurations
ensure energy recovery with minimal inrush current conditions. The unifiedDCAC Drive system ismodelled using MATLAB/Simulink/ Sim-power software environment
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.