power when the wind speed is greater than the rated speed. The simulation results performed on MATLAB/Simulink show the variations of the wind turbine generator output power, rotor speed
midpoint voltage is obtained with a specific pulse width modulation (PWM) strategy. Simulation results carried on MATLAB/SIMULINK model design show the effectiveness of the proposed solution
extend the PAC approach for UPQC-S, is presented in this paper. MATLAB/SIMULINK-based simulation results are discussed to support the developed concept. Finally, the proposed concept is validated
control strategy ba sed on linear matrix inequality (LMI) is proposed. Using Matlab/S imulink, the simulation results show that the propo sed sliding mode control strategy can effectively reduce
method was used in the model. Solution algorithms were developed and MATLAB program implemented to simulate the velocity distribution of coolant flow at a 30 kW nominal power. The fluid
help to increase the load ability margin of the power network. Modelling & simulation is performed using MATLAB SIM power system block set for evaluation
number of power switches compared to a traditional cascaded multilevel inverter. Simulink/MATLAB is used to simulate the circuit operation and for control signal
Ratio (FDR) are used for characterizing the performance of the proposed method. Simulations are conducted on MATLAB to illustrate its efficiency by showing that it is capable of accommodating different
smooth transient response then that of notch filter based PLL the whole simulation is done in matlab/ simulink and a comparative statement is established
circuit is minimized nearly zero under no-load condition. In this paper, simulation is done using MATLAB/SIMULINK and experimental results are presented
load. This paper describes DVR using Proportional Integral (PI) control technique. The simulations are performed using Matlab/Simulink’s SimPowersystem Toolbox
methods. This has been tested in IEEE 39 bus system and the simulations are done in MATLAB platform. Apart from the proposed ANN method, an advanced methodology called Adaptive Neuro
drive, being high frequency, is done in PSIM and the control circuit simulations are done in MATLAB. Later, both MATLAB and PSIM are coupled by SimCoupler to obtain the speed
ensures that the shunt APF can very well achieve different compensation purposes. Simulation results obtained with MATLAB and testing results on an experimental shunt APF are presented to validate