prepared ZnO–NPs were characterized by transmission electron microscopy (TEM), powder X-ray diffraction (PXRD), UV–visible spectroscopy (UV–vis) and Fourier Transform Infrared (FTIR) spectroscopy. Spherical ZnO–NPs were
periodic in short range in direction z. In the present contribution, x-ray diffraction and transmission electron microscope studies were carried out on two copper based CuZnAl and CuAlMn alloys ... These alloy samples…
adsorbent materials in RNA purification, they will be characterized by low angle X-ray Diffraction (SAXRD, Small-Angle X-Ray Diffraction), Raman spectroscopy, thermal analysis and gel electrophoresis
samples without and with polysaccharide was characterized using ultraviolet-visible (UV-Vis) spectroscopy, X-ray diffraction (XRD) and Fourier-transform infrared coupled with attenuated total reflection instrument…
Sample composition is confirmed using Energy Dispersive X-Ray Spectroscopy (EDS) and X-ray Diffraction (XRD). Results show nanomaterial Cu to have a much smaller grain size than conventional
functionalized silicon chips and annealed to the multi-lamellar RBC membranes. High steadfastness X-ray diffraction has been used to regulate the molecular structure for the stacked membranes. We current
characterized by intrinsic viscosimetry, 1H nuclear magnetic resonance, infrared spectroscopy and X-ray diffraction. Copolymer micro particles loaded with ibuprofen were prepared by an oil-in-water (o/w) emulsion
phase constituents of the powders before and after consolidation were mainly characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive…
obtained via electrospinning. Each NF was characterized using Fourier transform infrared spectroscopy and X-ray diffraction. The scaffold morphology and average diameter of the NFs were determined using scanning electron
cyclic conditions. The thermogravimetric technique was used to establish the kinetics of corrosion. X-ray diffraction (XRD), scanning electron microscopy (SEM) and electron probe micro analyser (EPMA) techniques were…
reduction and photo / electrochemical CO2 conversion reaction kinetics. The in-situ synchrotron X-ray absorption, emission and diffraction spectroscopies were conducted to systematically investigate the materials…
ultrasonically atomized nanocrystalline ZnO powders were studied. The powders were characterized using X-ray diffraction (XRD), transmission electron microscopy (TEM), selective area electron diffraction (SAED)…
failures. The foam scraper was only removing loose deposits in the pipeline. The X-Ray Diffraction (XRD) analysis indicated that the top layer of the deposits consisted of 50% sand
samples were determined in this investigation. Microstructure studies were conducted using X-Ray diffraction (XRD), Thermogravimetric analysis (TGA/DTG) and Attenuated Total Reflectance Fourier Transform Infrared…
combustion is reported. The synthesized samples were characterized by Fourier transform infrared spectroscopy, X-ray diffraction, scanning electron microscopy electrical and dielectric properties (resistivity and…
Further, the optimized formulation was characterized by differential scanning calorimetry, powder X-ray diffraction, and ATR-FTIR spectroscopy. A decision tree to aid in selection of solvent, anti-solvent
molar ratio. The structural properties have been analyzed in detail by X-ray diffraction (XRD), the patterns shown improvement in the quality and size of the ternary crystals with increasing
V2O5@WHS) nano-flowers- like structures was successfully synthesized by solvothermal method. The X-ray diffraction analysis of the materials revealed the orthorhombic structure V2O5. No other peaks from ... pattern…
proliferation, were studied in vitro on the scaffolds’ surface. Samples were characterized by X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM) coupled with Energy Dispersive Spectroscopy (EDS), Attenuated…
scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDX), optical microscopy (OM), X-ray diffraction (XRD), and Raman spectroscopy (RS). The mechanical properties were evaluated by compression tests
auto-combustion technique. The as-prepared samples were characterized by X-ray diffraction (XRD) and SEM. XRD analysis confirms the cubic spinel structure with appearance of secondary phase
were synthesized by solid state reaction. X-ray diffraction (XRD) patterns for all the samples almost match with standard pattern of SmCrO3. The complex dielectric properties of the ceramic samples
have been investigated for the pure phase of Mo2C and MoC. For example, X-ray diffraction (XRD) measurements have been performed to get information about the structure and phases obtained
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.