sand formation at an environmental temperature of 25°C. A 3D finite element (FE) model of the formation is developed in ABAQUS to examine the average stresses and deformations ... formation was observed to occur mostly…
regular pre-code reinforced concrete buildings. Evaluation of vulnerability is performed through conventional non-linear static pushover computations, using specialized finite element software. Three limitations were…
novel non-linear power point tracking method of photovoltaic system (PV) based on synergetic control strategy is proposed. This technique uses a synergetic control strategy to achieve the maximum power ... cell…
paper addresses analytical modelling in fiber optics engineering. Attributes and significance of predictive modelling are indicated and discussed. The review is based mostly on the author’s research conducted ... fibers…
infusion rate (GIR), respectively. To explain the observed differences in BA, a pharmacokinetic-pharmacodynamic model was developed and BAs were predicted at different doses of inhalation insulin with the fixed…
been an enquiry hotspot that involves multiple branches of physics like wave optics, non-linear optics, fluid dynamics and natural philosophy. With the speedy development specially of ultrafast laser-matter ... NSRs and…
Ultrasonic velocity has been measured using single frequency interferometer at 2 MHz (Model F-81). From the experimental data, other related thermodynamic parameters, viz adiabatic compressibility, intermolecular free…
social insects. The methods of this research have been based on verifications at experimental modeling via computer graphics and by rapid prototypes that have been built from recent literature data ... areas without…
social insects. The methods of this research have been based on verifications at experimental modeling via computer graphics and by rapid prototypes that have been built from recent literature data ... areas without…
constant electric and magnetic fields with non-zero scalar product between them, the non-linear Maxwell equations produce the magnetic response, which carries a single point-like magnetic charge. Unlike ... date…
Ultrasonic velocity has been measured using single frequency interferometer at 2 MHz (Model F-81). Adiabatic compressibility, intermolecular free length, acoustic impedance, surface tension and other acoustical…
between two infinite parallel perpendicular flat plates is investigated. The Maxwell Garnetts (MG) nanofluid model is used in this work. The basic partial differential equations are reduced to the ordinary ... problem…
principal component analysis (PCA) method, the multiple linear regression method (MLR), the multiple non-linear regressions (MNLR) and the artificial neural network (ANN). The predicted results of various study…
Power electronic devices are non-linear loads; the non linear nature of these switching devices causes harmonic current injection into the ac mains there by polluting the Power Quality ... drives (VCIMD). The proposed…
alkylates) with different molecular architectures and physical aspects (viscous, sticky, rubbery and solid) as model polyester elastomers. Mechanical properties at both small and large strains and adhesion performances…
alkylates) with different molecular architectures and physical aspects (viscous, sticky, rubbery and solid) as model polyester elastomers. Mechanical properties at both small and large strains and adhesion performances…
backup energy supply and storage systems in off-grid and on-grid microgrids, as modeled by our group at the University of Twente [1-3]. By lining up these ... gold surface may change upon cycling by cyclic voltammetry…
Back Propagation Artificial Neural Network technology. This study was based on time series ANN model that takes a sequence of past LST values, understand the pattern of change within ... part of deep learning…
used to develop 3D virtual prototype simulators using the ADAMS software. The virtual prototype models are validated using real-world data to generate the driving torque for the various ... effect of load on oil sand…
evaluated several methods of dimensionality reduction, including linear and non-linear methods, such as principal component analysis, Isomap, locally linear embedding, and diffusion maps. A series of criteria was used…
each point of material. The parameters for description of metal behaviour by the mathematical models of sheet metal forming are normally taken from a simplest mechanical test such ... that the deformation procedure of…
aerodynamic characteristics can be accurately estimated using the shear stress transport (SST) turbulence model. The equation describing the spinning and elastic movement was established. The projectile longitudinal…