recent years, significant technological advances have been made in particle chemistry performance, system optimization, detector design, and data processing and control. When brought together, the individual…
Preformulation studies were conducted to determine the physical characteristic of drug like bulk density, particle size and solubility. Solid dispersions were prepared by hot melt method by employing 6 different…
administration route often are the reasons for this. The high and self-optimizing deformability of typical composite transfersomes membrane, which are adaptable to ambient tress allow the ultra deformable transfersomes…
factorial designs. The optimized nanosuspension was lyophilized using mannitol (1:1 ratio) as a cryoprotectant. Characterization of nanosuspension was performed by particle size and size distribution, drug ... content…
into the primary particles from which it was prepared.Tablets and capsules which need rapid disintegration, the inclusion of the right disintegrant is a prerequisite for optimal bioavailability. Superdisintegrants are…
vivo evaluation. The optimized microemulsion formulation was found to be o/w type emulsion by pseudo ternary phase diagram and having mean particle size of 138±4.5 nm. The results
transparency, droplet size, zeta potential, viscosity, % assay, and stability study etc. Particle size and zeta potential of optimized microemulsion were found to be 12.3 nm, -6.34 mV respectively. Drug content
observed that an influence of diffusion on drug particles with increase in the concentration of HPMC. The optimized formulation shows the controlled drug release (86.32%) than aqueous drug solution
further elucidated using multiple liner regression analysis (MLRA). The obtained results showed that particle size (nm) and rate of dissolution has been improved when nanosuspension prepared with the higher…
delivery of indinavir sulphate from ethosomes. All the system were characterized for vesicle morphology, particle size and entrapment efficiency by Scanning Electron Microscopy , Transmission Electron Microscopy…
method using ethyl cellulose and HPMC K100M. A full factorial design was applied to optimize the formulation. Preliminary studies revealed that the concentration of polymer and stirring speed significantly affected…
stirring speed X2 on dependent variables percentage mucoadhesion, drug entrapment efficiency and particle size. The optimized formulation exhibited a high drug entrapment efficiency of 60%, swelling index 0.42…
light scattering detection (ELSD). Altech Altima HP HILIC column (250 x 4.6 mm, 5μ particles) was used along with the mobile phase consisted of water and acetonitrile in a linear ... nebuliser temperature and impactor…
develop an optimized gastroretentive drug delivery system of Diltiazem HCl Hollow microspheres by the optimization technique. The Diltiazem HCl microspheres were prepared by non aqueous emulsion solvent evaporation…
separated on a 250mm×4.6mm C18 column packed with 5 μm particles. The mobile phase, optimized through an experimental design, was a 50:25:25 (v/v/v) mixture
objective of present study was development and optimization of floating microspheres of famotidine. The floating microspheres can be prepared for the improvement of absorption and bioavailability of famotidine by…
maximum entrapment efficiency and drug content was 69.1% and 60.63%, shown by optimized formulation. Particle size of optimized formulation was 0.248 μ shown by Zetasizer. Spray drying of optimized formulation
formulations were characterized for particle size, mucoadhesion, drug loading, entrapment efficiency, in vitro release studies. A 32 factorial design was used to optimization. The dependable variables were PVA…
Method .The prepared beads evaluated for various parameters lke encapsulation efficacy, swelling index, Mean particle size, flow properties and in vitro release. The yields were varies from ... which encourage the…
vitro evaluation of Floating Drug Delivery System (FDDS), prediction of the drug release, and optimization of stirring speed and polymers concentration to match target release profile was investigated. Floating…
beads sphericity, size distribution, mean particle size varies. The dissolution test was carried out in a USP paddle dissolution apparatus. The formulation was optimized by 32 factorial design. The optimized
optimized by using Central composite design (CCD) in resoponse surface methodology (RSM). Separation of domperidone and ilaprazole was achieved on phenomenex C18 column (150 X 4.6 mm i.d, 5μ particle ... found to be…
used in the fabrication of microspheres. Prepared microsphere formulations were characterized for percentage yield, particle size analysis, entrapment efficiency, invitro release behavior, differential scanning…
compatibility was studied by FTIR studies. The prepared Microbeads were evaluated for swelling ratio, particle size, and drug entrapment efficacy, scanning electron microscopy, differential scanning calorimetry…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.