Validation revealed the method is rapid, specific, accurate, precise, reliable and reproducible. Calibration curve plots were linear over the concentration ranges 8 to 32 μg/mL for Ketoconazole. Limit
Quantitation (LOQ) were obtained from the calibration curve. The fentanyl extraction calibrator solutions produced a Linear Dynamic Range (LDR) from 1-500 ng/mL with an R2 value
λmax) for Atorvastatin & Clopidogrel was found to be 246nm &202nm respectively. The calibration curve of was linear over the range of 5-25μg/ml for both Atorvastatin and Clopidogrel
initial rate method was adopted for constructing the calibration curve which was linear in the concentration range of 1.5 ×10-5 M -1.85 ×10-4 M corresponding
standard deviation of relative retention times and relative peak areas, were acceptable. Calibration curves showed good linear regression (R2 > 0.9935) within test range. The LODs and the LOQs
Value for telmisartan and ramipril was 0.673 and 0.353 respectively. The linearity regression analysis for calibration showed 0.999 and 0.998 for telmisartan and ramipril with respect to peak area
polynomial regression data for the calibration plots exhibited good linear relationship (r = 0.9998) over a concentration range of 100 – 700 μg/ml and the linear regression equation was y=9559x
mobile phase at a flow rate of 1.0 mL/min. The calibration curve obtained was linear (r ³ 0.99) over the concentration range of 0.20-499.04 ng/mL. The results
Validation revealed the method is rapid, specific, accurate, precise, reliable and reproducible. Calibration curve plots were linear over the concentration ranges 10-50 μg/mL for Lapatinib. Limit of detection
detection ranged from 1.4 to 1.7 nM for the target analytes. Calibration graphs displayed satisfied linearity with R2 greater than or equal to 0.9978 and relative standard deviations
phase. Finally, pharmacokinetics of EF in rabbit serum was investigated. Results: All calibration curves displayed excellent linearity (r2>0.99) within 1.2~24 ng/mL. The assay was specific, precise
mobile phase at a flow rate of 0.6 mL/min. The calibration curve obtained was linear (r2 ≥ 0.9900) over the concentration range of 0.500-500 ng/mL. Method validation
column temperature was 40°C. All calibration curves showed good linear regression (R2 > 0.9995). The average recoveries ranged from 97.06 to 104.44%. The RSD was below 4.2%. Four compounds remained
hydrochloride was found to be 0.62±0.02 and 0.18±0.02, respectively. The linearity regression analysis for calibration showed 0.999 and 0.999 for flunarizine dihydrochloride and propranolol hydrochloride with respect
respectively. Validation revealed the method is accurate, precise, reliable, and reproducible. Calibration curve plots were linear over the concentration ranges 0.1-2.0 μg/mL for Impurities
3μM (±2SD, Accuracy (%) ±4, %CV ±1.5, STD <5). calibration curves showed good linearity mainly over six orders of magnitude with a correlation coefficient R2 > 0.99. Conclusions: These methods were developed
abrine and 0.30 μg/L for ricinine.A 7-point standard calibration curve showed good linearity for both analytes (r2 = 0.990) with a CV of <10% for replicates.Spiked fortified food matrices
pumped at a flow rate 1.0 mL min-1. The calibration curves showed good linearity with correlation coefficient higher than 0.998 for all analytes in the range
with retention time values of those degradation products in stressed samples. The calibration curves showed good linear regression (r2>0.999) within test ranges. The method showed good reproducibility and sensitivity
mobile phase at a flow rate of 0.9 mL/min. The calibration curve obtained was linear over the concentration range of 0.10?500 ng/mL with r2 > 0.99. Method validation
directly analysed by GC without undergoing any clean up step. Calibration curves showed good linearity (0.5-50 Ã?¼g mL -1 , correlation coefficient: 0.9999). Recovery test revealed that the method
method was validated according to the ICH guidelines. Results: The calibration curves showed good linear regression (r2 > 0.999) within test ranges. Specificity of the method was assessed using PDA profile
opioid analgesic in pure and pharmaceutical dosage form is described. The calibration curves were found linear between fluorescence intensity and drug concentration in the range of 50- 300 ng/mlwith
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.