Fe2O3=4.22 wt% and TiO2=0.64 wt%. Structural characterization is performed using X-ray diffraction (XRD). XRD results suggest that goethite (Fe2O3) and quartz are present. Among them goethite ... presence of strong…
Monolithic surface-emitting semiconductor lasers hold promise for significant advantages over edge-emitting lasers in terms of both reliable operation and manufacturing cost. Grating-coupled episode-down distributed…
RSA3 rheometer and tensile tests by an electromechanical testing system. X-rays diffraction, confocal laser scanning microscopy (CLSM) and SEM were assessed to analyze the nanoclay incorporation into the material
fiber lasers. We have performed analyses of power scaling limits of single aperture, diffraction limited fiber lasers and understood the physical mechanisms that limit scaling beyond
sample surface by two beam interference of a single near infrared femtosecond laser pulse. In general, diffraction gratings were fabricated on optical materials such as silver-halide emulsion, photoresist ... cost will…
been used for phase-locking near-infrared (IR) lasers to high pulsed (10 W) and CW (1.6 W) near diffraction-limited (D.L.) powers. The structures are analogous to 2nd-order ... coherence over large apertures has been…
reasonable finite power. The nearly non-diffraction properties of MGM show their potential to lots of practical applications, such as: optical interconnections, laser machining, collimation and measurement, optical…
light reflected back to the silica waveguide is coupled out, measured, and or diffracted. A commercial laser puller provides 10-20 nm end radii at almost no cost. Metal coating
fabricate over 300 samples with different parameters by exploiting two-photon polymerization direct laser writing technique. The side of the hexagonal comb is varied from ... fabricated structures are studied by optical…
diffraction analysis of the surface structure were conducted to detect the surface changes. Results: The hardness of the porcelain specimens was not significantly increased with 2 watt CO2 laser ... excimer laser when…
laser beam, or filament - induced breakdown spectroscopy (FIBS). Femtosecond laser filamentation starts when Kerr-induced self-focusing overcomes beam diffraction. When a threshold power is reached, the transverse…
radiation damage. These problems have been avoided through room temperature diffraction at an X-ray free electron laser (XFEL). Data were collected at an XFEL source to a resolution
laser intensity of 0.44 W. The laser spots were spread on material surface by diffractive optical elements, and monitored using high-speed camera. The laser signal was distinguishable even
pressure of gas (O2 or Ar), type of laser pulse, and substrate temperature. The samples were analyzed using X-ray diffraction, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy ... data were collected…
rainfly (Termite) by a simple, non-invasive, real time transmission optical diffraction technique using monochromatic CW lasers and broadband femtosecond laser pulses. Our observations directly demonstrate the coherent…
thin film grown on (001) LaAlO 3 single crystal substrate by pulsed laser deposition. X-ray diffraction (XRD) results confirming that the film has good crystalline quality, single phase
linear optical properties have a wide variety of potential applications inthe field of laser optics and communication. Succinic-Picrate crystals doped with copper sulphate that are yielded by mixing ... grown crystals…
this approach: 3D recording of nanostructures with a low power CW laser and nanostructures with dimension far beyond diffraction limit, were obtained by 3D quantum optical lithography using a coherent
emitting diodes and lasers. However, the diameter of nanowire waveguides and laser cavities is fundamentally constrained by the diffraction limit of the guided photonic modes. Hybrid metal/semiconductor nanowires…
consecutive cycles. The milled powder was characterized using laser granulometry, BET method, X-ray diffraction and scanning electron microscopy techniques. The crystallite size was calculated using Halder-Wagner methods
biomedical and material science at ELI Beamlines needs to control the delay of synchronized laser beams down to femtosecond precision. The aim of this student project was to apply interferometry ... sciences and for…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.