metal surface without modifying the mechanism of corrosion process. The surfactant acts predominately as cathodic inhibitor. The inhibition efficiency increases with an increase in the surfactant concentration. Maximum…
indicated that the used compound act as mixed type inhibitors. The slopes of the cathodic and anodic Tafel lines (âc, âa) are approximately constant and independent of the inhibitor concentrations
polarogram recorded for the industrial effluent in potassiumthiocyanate as a supporting electrolyte showed two cathodic peaks at -0.63 V and -0.93 V vs. saturated calomel electrode which were confirmed
electrochemical cell was considered as the objective function; and the type of cathode, the kind of acid that used az the electrolyte of the cell, and the temperature
anionic surfactant inhibitor have been investigated using weight loss measurements, Extrapolation of cathodic and anodic Tafel plot and Linear Polarization Resistance (LPR bubble test). The data obtained from
constituents, pH, temperature and current density were optimized through Hull cell studies. Potentiodynamic polarization, cathodic current efficiency, throwing power studies were carried out. Salt spray test and…
electrodes. It was found that HMII andMPII can effectively increase the cathodic peak current of PCB- 77 and the electrocatalysis activity of themetal on electrochemical determination
ions had shifted the oxidation peak potential of the corresponding phenothiazine group to more cathodal position. By some electrochemical techniques, the electrode reaction processeswere investigated in detail and their…
techniques. The results indicate that these compounds act as inhibitors retarding the anodic and cathodic corrosion reactions. The presence of inhibitors does not change the mechanism of either hydrogen evolution
were carried out on Li/ /LiCoO2cellswith a lithiummetal foil as anode and LiCoO2 filmas cathode of 1.5 cm2 active area using a Teflon home-made cell hardware. The silicon substrate
inhibitor and the potentiodynamic polarization studies clearly show thatATAis a mixedtype inhibitor for bronze, cathodic inhibitor for iron and anodic inhibitor for copper. The inhibition efficiency of ATA increases with
using 1MKCl as a supporting electrolye. Both ofloxacin and ornidazole exhibit reduction cathodic peak in given pH with peak potential at -1.25 V for ofloxacin and 0.35V for ornidazole
analysis. Effect of different parameters like current density, temperature, depolarizer concentration and nature of cathode material on yield percentage and current efficiency has been investigated. Number of electrons…
formulation tablet has been developed using differential pulse polarography. Tinidazole and ciprofloxacin produces a cathodic wave at -0.38 V and -1.30 V respectively versus S.C.E in a solution
reverse scan. In case of benzotriazole one clear reduction peak was observed in the cathodic scan and no anodic peak was seen. Effect of pH, sweep rate, analyte concentrations
traction axis. For each of thema cyclic polarisation run was performed between the cathodic domain and the solvent wall in the anodic side. The behaviour in the active state
linear sweep voltammetry method. In the presence of halogen-organic compounds, the cathodic current at a given potential was significantly higher than the background current
consisting of EDTA (1mM), O2 (10mg/l), Na2SO4 (0.1M), the graphite cathode section volume of 53ml consisting electrolyte of Na2SO4 (0.1M). Concentrations of NB during electrochemical degradation were
against the corrosion of Carbon Steel. Polarization data indicated that the studied compound is cathodic inhibitor without changing themechanismof hydrogen evolution reaction. The adsorption of inhibitor on Carbon Steel…
interface and the successive stability constants of this system have been evaluated. The cathodic shift in E½ coupled with decrease in diffusion current with increasing ligand concentration is observed during
demonstrated the presence of four welldefined hemoglobin fractions, one major component (fraction I), showing cathodic migration and three others faster than fraction I with anodic migration. When the samples were
rate of electrodeposition of copper plates was determined bymeasuring cathodic limiting current in absence and in presence of carbohydrates as(Glucose, fructose, mannose, sucrose, lactose and maltose). It is found
reach a maximum value near their critical micellar concentrations. These surfactants act on the cathodic hydrogen reaction without modifying its mechanism. Nyquist plots of iron/1M HCl systems obtained
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.