using either the Discrete Cosine Transform (DCT) or the Discrete Sine Transform (DST). The simulation results show that adding the DST to the system improves the visual quality of reconstructed
short time. These methods are tested in MATLAB, and their results are obtained. The simulation results show an improvement in input output response of CSC-STATCOM
power energy conversion to reduce the cost of active power switches and control circuits. Simulation results demonstrate a satisfactory performance of the proposed topology, which is especially suited
speed controller in order to minimize torque ripple, flux ripple, and stator current distortion.The simulation results of BLDC drive employing conventional PI and PSO based PI controllers is compared
fluctuating nature of the available spectrum. To study routing algorithm a model that can simulate CRNs routing protocol needs defining. This paper presents a comprehensive summary of different routing models
proposed to resolve the speed tracking problem for DTC of BLDC motor drive. The simulation results of DTC of BLDC motor drive with PI & SMC controllers are compared
level Trinary Cascaded Hybrid Multi-Level Inverter (TCHMLI) simulink model. The obtained simulation results are analysed by the measure of Total Harmonic Distortion (THD), Peak Voltage (Vpeak), Root Mean Square
achieving Maximum Power Point Tracking of the PV generator. The proposed system is simulated using MATLAB/SIMULINK and tested for power quality improvement under the maximum Power Point Tracking
cause power quality issues at distribution end. In this paper, an analysis and simulation of a PV interactive shunt power active filter (SPAF) in single phase circuit. This system ... algorithm and for gating signal…
proposed PWM strategy using reference signals generated by switching angle method and the simulated outputs are validated by comparing the performance with the conventional PWM strategy using the proposed
which makes the area overhead minimal and keeps the extra power consumption low. Extensive simulation results are given to accurately estimate the probability of error detection for different code sizes
work, 1.1V, 6-bit charge scaling DAC using split array is designed and simulated. This design consists of parallel array of binary weighted linear capacitors to achieve high resolution
measured for 2.4 GHz frequency using co-axial feeding technique with High Frequency Structure Simulator (HFSS) and experimentally fabricated antennas are analyzed with Vector Network Analyzer (VNA). Optimization of patch
overall cost and complexity are greatly reduced particularly for higher output voltage levels. The simulation is to be done for 1-phase five level inverter for R-L, 1-phase ... phase Induction Motor load and also Seven…
proposed antenna shows broadside radiation characteristics. The design of the antenna is described. The simulated results are presented and discussed. These antennas are useful for the applications such as WIFI
lighter materials are reduced to less than 10%. Due to the growing interest in simulating chemical processes, chemical engineers, and construction of the project feed the furnaces and furnace simulation ... examined. In…
pathway leading to various inflammatory diseases. In this study in silico enzyme-inhibitor binding simulation experiment was performed between eight phytochemicals and Janus kinase enzymes
size of prepared niosomes. Drug release profile from different prepared proniosomal gel formulations in simulated vaginal fluid (SVF) was studied in comparison to the commercial product of terconazole
patients and middle aged/older healthy controls are presented in two rural driving simulation environments: High traffic with and without distraction (conversation). Moreover, total number of crashes in unexpected…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.