network for evaluating the performance of our protocol. We can prove through simulation results that our protocol is highly efficient in handling the address collisions and reducing the control traffic
made. People can flexibly design the filter according to their idiographic requirements. We provide simulation results that show its efficiency and performance
designs and achieves better speed and power performance. Based on post-layout simulation results using TSMC CMOS 90-nm technology, the proposed design outperforms the conventional P-FF design
this paper there are two parts where one part is based on the VHDL simulation of encoder and decoder and second part is based on hardware, in which all these ... simulations are implemented on SDR (an FPGA). This paper…
Loops is used to detect the phase angle of the grid voltage. A Simulink simulation model and results where the inverter output is controlled to match a local load
Boost converter, PWM voltage source inverter, series injection transformer and semiconductor switches. The simulation study is carried out using MATLAB and results are presented
distillation column and also to control the product stream composition. Results from the simulation are helpful for initial steps of a petroleum project feasibility study and design
prevents disconnection while achieving the desired voltage support service which can be analyzed and simulated by using Matlab/Simulink environment. The main contribution of this work is the introduction
current. Thus the effectiveness of the system is very improved. The proposed system is simulated under PI controller and fuzzy controller. This results in the better quality of power ... emphasize that the proposed…
STATCOM is proposed as a VAR compensator. It can be concluded from the simulation results that the proposed STATCOM joined with the designed damping controller can effectively improve the stability
switch with clamping to the dc midpoint, is proposed. The topology is simulated and experimentally validated, and a comparison with other existing topologies is performed. High conversion efficiency
proposed method is able to eliminate the high number of predetermine harmonics. Simulation work is achieved by using the MATLAB software which verifies the proposed method and finally Total Harmonic
Rayleigh channel. The reference model SISO, MISO, MIMO(2X2) are designed and simulated in MATLAB. The evaluation of Bit Error Rate (BER) and Signal to Noise Ratio (SNR) performance
pq208 Spartan 3E board. VHDL language is used as a design entry. It is simulated and synthesized using Modelsim 6.4a and Xilinx 8.1i ISE respectively. With this
power, delay as well as the power delay product for both the multipliers. The simulations were done using HSPICE tool in 45nm, 32nm, 22nm and 16nm CMOS technologies. The multipliers
healthy fixed and variable DFIG wind energy conversion system. All these scenarios have been simulated with the help of the simulation program using MATLAB and its inbuilt components provided
Phase Induction Motor is done by MATLAB/SIMULINK MODEL BASED ON POWER SYSTEM BLOCKSET. Simulation shows the flux and torque ripples are greatly reduced. Also, PID Controller is used
Phase Induction Motor is done by MATLAB/SIMULINK MODEL BASED ON POWER SYSTEM BLOCKSET. Simulation shows the flux and torque ripples are greatly reduced. Also, Proportional Controller is used
with different loads. The 3-ɸ VSI is fed from a AC-DC converter. Simulation results of output currents are obtained and their THD’s are compared using MATLAB/Simulink