problem of voltage sag and swells and its severe impact on non linear loads or sensitive loads. The dynamic voltage restorer (DVR) has become popular as a cost effective solution ... protection of sensitive loads from…
current THD values among DSTATCOM, DVR & UPQC connected to a system with a distorted load. There after a novel design of UPQC is implemented using PI-Resonant control strategy ... further mitigating THD’S of voltage and…
noise or ripple in the terminal voltage. As there is any variation in the load, the current angle may differ. With the help of this phase angle difference the speed
Nonlinear loads generate a harmonic and reactive current, which leads to poor power factor and harmful disturbance to other appliances. Active power filters are one of the viable solutions ... eliminate the…
which we normally use for our building construction. Red clay bricks are used for load bearing as well as for filler walls of RCC frames in high rise structures. There
giving a higher capacity. However if the concrete core and the steel tube are loaded simultaneously the steel tube expands more than the concrete core under moderate loads since Poisson ... tubular columns. But they are…
measured by segmenting the ultrasound images of carotid artery. First, the ultrasound image is loaded and the image is enhanced by reducing the speckle noise by using wavelet filter. Then
tasks which attain maximum resource utilization, minimum response time and a well-balanced load across all the resources involved in a grid. Faulttolerant scheduling is an imperative step for large
based on the network topology and configuration parameters, and not depend on the traffic load on the routers and links. Routing optimization is done using Genetic Algorithm in Minimum Spanning
presented.A bridgeless SEPIC rectifier for power factor correction with low conduction losses and load regulation is presented.The absence of an input diode bridge and it can achieve low conduction losses
carried out under very challenging conditions, namely step changes in irradiance, step changes in load and partial shading of wind array. The proposed method in simulation shows it is efficient
quality in distribution system by injecting voltage in series for the protection of sensitive loads against voltage sags and voltage swells. The performance of the DVR depends on control technique ... Simulation results…
interdependencies among basic converter parameters such as dc voltage gains, transistor duty cycles, and load current levels are much more complicated than those of the single-output counterpart. In this ... loop…
inherently compatible and can be readily implemented, without the need of a dumping load for the RPM. Following the establishment of a dynamic system model, the study develops the guidelines
gear box, Pulse Width Modulation (PWM) Current Controlled Voltage Source Inverter (CC-VSI), Electronic Load Controller (ELC), three fuzzy logic PI controllers and one Hysteresis Current Controller (HCC). A dump ... load…
parameters supported for vertical handover. Here the parameters handoff latency and the network load balancing are included in the algorithm to provide the seamless service to the user
back of only used Fuzzy logic control switching frequency will not constant on during load condition. AFNNC could be introduced. However, the computation cost is much higher than conventional system
decades. Unified Power Quality Conditioner (UPQC) is one of the CP devices whichmitigates both load current and supply voltage problems simultaneously. In this paper the development of UPQC with transformer
converter can be designed to work in CCM mode over a wide range of load variation and input voltage. This results in a lower output inductor current ripple than that ... simulation. The result shows that the new…
both the distribution network (public grid) and in the power-supply system (nonlinear load) connected to the network. In this method harmonic components can effectively prevented from flowing into
power from several input sources and to supply the regulated output voltage for the load from the power sources. As the conventional source of energy is rapidly depleting ... Wind source. A storage element battery is…
Automatic Generation Control (AGC) or Load Frequency Control is a very important issue in power system operation and control for supplying sufficient and reliable electric power with good quality ... power system .An…
future. Comparatively with the past and due to the progressive integration of the nonlinear loads in the grid, the principal role of a Wind Energy Conversion System (WECS
interconnected power system, as a power load demand varies randomly both area frequency and tie-line power interchange also vary. The objectives of load frequency control (LFC) are to minimize ... with conventional…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.