Sensorless Speed Control for PMSM Based On the DTC Method with Adaptive System
method reduces the torque ripple while achieving a good dynamic response. Simulation results are presented and show the effectiveness of the proposed method
Articles, journals and conferences in one search. An exact title, DOI or ISSN is listed first.
In the search box: "exact phrase" · -leave out · OR · prefix* · title: author: journal:
method reduces the torque ripple while achieving a good dynamic response. Simulation results are presented and show the effectiveness of the proposed method
structure that gives joint ML estimates of multipath channel and the transmitted data sequence. Simulation results indicate that our proposed scheme can improve performance of cell edge users in multicell
initial conditions. The initial conditions are obtained from a look up table. A MATLAB simulation was carried out and the FFT analysis of the simulated output voltage waveform confirms
opens up new applications but also extends the operating battery range in existing applications .Simulation results confirmed the dc equations and the “mix-voltage” conversion of SIDO buck converters ... analyzed. Based…
adaptive RPM control. The power tracking performance and power limiting capability are verified by simulation and experiment
consume the maximum output power from the generator. Dynamic and steady-state performance where simulated using Matlab/Simulink software
matrix inequalities, sufficient conditions for the existence of the regulator and observer are derived. Simulation and experimental results are given to verify that the proposed digital control method
system during Misfire and fire-through faults in order to maintain its dynamic performance. Simulation results without and with SMES connected to the system are presented, compared, and analyzed
much similar to Dynamic Voltage Restorer (DVR).This scheme was found beneficial and the simulation (using MATLAB/SIMULINK) results prove that the voltage and current control was found good
proposed converter is controlled by a phase shifted carrier pulse width modulation technique. Simulation results are presented to validate the effectiveness of proposed I-DFCM converter. Furthermore, switching losses
converter is explained and its feasibility is confirmed with experimental result obtained from the simulation. The result shows that the new converter has better power factor for light load operation
power grid can also be effectively mitigated by the proposed control scheme. The simulation of the proposed model was carried out using MATLAB/PSAT and the effective performance was analyzed
explores the application of PWM methods in the estimation of power electronic waveforms are simulated using MATLAB
closed loop performance of MIC. The different operating modes of the proposed converter are simulated using MATLAB
appropriate switching angle is to be proposed. The proposed project is to be simulated by using MATLAB
pass filter. The operation modes of the proposed system are simulated using MATLAB and results are validated
same amount of DG power, decreasing the losses and improving the voltage profile. The simulation of the proposed model was carried out using MATLAB/PSAT and the effective performance
total number of switches. To develop the model of the multilevel inverter, a simulation is done by using the MATLAB/SIMULINK software
Many photovoltaic inverter designs make use of a buck-boost sinusoidal waveform
system has been studied for various speed and load conditions using MATLAB simulation tools
lower-level controller, first the performance of the controller is verified in MATLAB using simulation, and then the code is hard-coded in embedded C and ported into the microcontroller ... This provides a methodology…
individual instrumentation requirements to measure and control system variables. MATLAB software is used to simulate the model. Several endurance will be carried out to investigate wind and diesel- biodiesel blend
advantages in avoiding different type of attacks from malicious nodes. Finally, using NS-2 simulator, the results shows that ESKMS is more energy efficient and provides a longer network lifetime
multiplying the overlap grade by the overlap area gained from a set of sensors. Simulation results show the effectiveness of this approach of sensor selection in terms of improving
entire system consists of PMSG, the boost converter and the storage system is achieved. Simulation results investigate the good performance of the proposed approach with the help of MATLAB/SIMULINK
For authors and organisers
Find the right journal for your paper and submit your manuscript.