various sizes at different locations. Two categories of systematic analyses are carried out using finite element model of spur gear. In the first category of analyses emphasize is given
geometry of the wing-fuselage attachment bracket of a six seater transport airframe structure. Finite element method is used for the stress analysis. Rarely an aircraft will fail
bending modulus (21.9±4.1 kPa with curvature VS 39.3±3.6 kPa against curvature). A finite element approach (ANSYS) was used here to simulate the three-point bending tests
bending modulus (21.9±4.1 kPa with curvature VS 39.3±3.6 kPa against curvature). A finite element approach (ANSYS) was used here to simulate the three-point bending tests
cover a lot of shapes (I, A, V, U, ?hook?, ?putter?), sometimes optimized by finite element analysis. They exhibit high or low aspect ratios (length vs. width) depending
five different shear wall positions founded on different soils has been carried out using finite element software. And the best location for the least spectral acceleration in the structure
detailed review on previous study of design of taper implant with the help of finite element method (FEM).A comparative study between cylindrical and taper implants is done
difficulty encountered in the analysis of these shells. Keeping above point in mind, a finite element analysis is carried out using an eight noded isoparametric element with five degrees
mechanical properties in comparison with monolithic metal. In present work with the use of finite element analysis factor of safety for rear axle housing is estimated for both hybrid composite
dimensional flow analysis is made using an unstructured finite volume technique. The space discretization is carried out using arbitrarily oriented tetrahedral elements. The cell-centered scheme, which is popular…
effect of coating thickness on 316L stainless steel on application of thermal cycling using finite element modeling and SEM results. Due to its ability to take high thermal loads
assembled using Assembly workbench of CATIAV5, this assembly is then converted to IGS file. Finite element modelling is completed in MSc Patran using the IGS file as geometry, the element ... different parts are…
shows a total bandwidth of 11.8%. DRA is analysed using Ansoft HFSS based on finite element method. Radiation characteristics of this DRA are observed at resonating frequencies. This
unsteady 3-D Thermo-Structural analysis is attempted in the present work. As finite volume method is the most popular method for fluid flow analysis. The same methodology is adopted ... elements and a new least square…
determined when to change the tool. Tool wear effect is also studied by Finite element Method (FEM) model. The FEM model is designed to carry out stress analysis
individual components are elaborated to analyse vibrations. The mathematical model is based on Finite Element Method. After simulating the dynamic behaviour of the rotor-bearing system with the normal operating
different specimens such as box beams, panels, and plates. The ansys software used for finite element analysis (FEM) of plates. In the present study an attempt is made to observe
still problematic and unclear. Result of analysis on an anatomically accurate and validated intact finite element model of the spine indicated that the strain energy density and stress (internal responses
outer tunic, the vitreous body, and the retina. Whereas most of the existing Finite Element Models (FEM) are extremely complicated in their structure and composition, and takes
slenderness ratio 0.5 to 3.5 to evaluate the variation of stress-strain by performing finite element (FE) solving procedure. The results show that the maximum stress is found in specimen
corona power loss in grid is described. The algorithm is based on a new finite element method (FEM) which allows computing corona power loss in high-voltage lines transmission
model of strain-induced growth in response to hemodynamic conditions, which we implemented using finite element methods. Model simulations show that the proposed model results in tissue growth that
fractures. Objectives : This paper presents the design and analysis of a hip implant using Finite element analysis. Fracture conditions are determined and the optimal design of the implant is obtained
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.