with PI controller, Sugeno-type Fuzzy Logic and Mamdani-type Fuzzy Logic using Matlab/Simulink in order to mitigate voltage sag. Then analyze the performance of DVR in order
tested for single and double transmission line systems with and without UPFC model in MATLAB/SIMULINK environment. By using a UPFC the oscillation introduced by the faults, the rotor angle
voltage levels and reduced THD in low modulation index region.Simulation and measurement results using MATLAB/SIMULINK illustrate the advantage of the proposed
harmonics is reduced and efficiency is enhanced significantly. Simulation work is done using the MATLAB/SIMULINK software which validates the proposed method and finally Total Harmonic Distortion is analyzed
used to eliminate the harmonics. Comparison of GA and PSO algorithms are done using MATLAB software to know the effectiveness of getting optimized switching angles
switches general ground is explained in detail. Design conformity, experimental and simulation results from Matlab and CCS are presented, as well as deliberations about the converter possibility are done
could achieve the improved efficiency of the system . The analysis has been simulated using MATLAB/SIMULINK. The simulated output shows very favorable result
performance analysis of Virtual Power Plant (VPP) in Smart Grid based on simulation in Matlab/Simulink . Two main Renewable Energy Sources namely PV and Wind generation systems along with controllable ... load are…
presents an efficient simulation model of PID controlled brushless direct current motor drive using MATLAB / SIMULINK is presented. The Brushless direct current (BLDC) motor is efficiently controlled by PID controller
elapsed in compression with minimum distortion in reconstructed image and is practically implemented using MATLAB 7.11.0 environment. The aim of compression is to achieve good quality compressed image making
data, and the simulation model of fuzzy logic controller used with PID controller in MATLAB/simulink is also obtained. Finally, from the result it can be seen that the settling
harmonics that are generated .In this paper we simulate a power system using MATLAB Simulation. Here we compare the performance of différent rating of power transformers and study the effect
used to control the DFIG. The constituents of the WECS are mathematically modelled in MATLAB/SIMULINK . The back to back PWM converter set up consists of the Rotor Side Converter
buck converter. The emulator interfaced with boost converter and simulated using MATLAB/SIMULINK. The fuel cell emulator performance was evaluated for changes in fuel flow rate and load
strategy in the Rotor and Grid side controllers. The simulations were carried out in MATLAB / SIMULINK and the results were compared to the conventional Crowbar protection scheme. The proposed control
network in terms of power quality issues, stability and voltage regulation.To study these issues MATLAB/SIMULINKSimpower system is used to model an IEEE 13 bus balanced industrial distribution system
relay (directional and non-directional) for microgrids and its performance verified by simulation in matlab/simulink. The paper also shows various steps involved in converting relays into a data converter
measuring sector local angle. The performance of the proposed control method is simulated using MATLAB/SIMULINK. It is concluded that the proposed method produces less torque and flux ripple
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.