porosity than these values of total porosity. 30 mass%, GCB the compressive strength increases and shows the maximum values than all hardened blended cement pastes. 2006 Trade Science Inc. - INDIA
between the planned and actual position of bone fragments. Findings: Assessment of bone fragment compression demonstrated a difference between the target and actual correction ranging from1.5% to1 3.2% (depending…
only few hours after the samples were taken in through compression tests. The results show that the average value of elasticity modulus of the internal compartment
Wada’s Constant are calculated using the above measured values. The excess parameters viz., excess molar volume, Excess adiabatic compressibility, Excess Intermolecular free length, viscosity deviation are also deduced…
been used to calculate adiabatic compressibility (β) acoustic impedance (Z) and isentropic compressibility Φk respectively. The values of sound velocities in aqueous solutions of PEGs of different concentration have been
flow angle of repose value was < 27°, Hausner’s ratio value was <1.25, and % compressibility was found 16.7%, which indicated good flowability with convincible oral administration.The required quantity
230bar) and the results obtained are compared with diesel (base line test values). A “computerized variable compression ratio multi fuel direct injection water cooled engine” is used for the performance
ceramic scaffolds of the Sr-HT Gahnite demonstrated outstanding mechanical properties with compressive strength and modulus values close to that of cortical bone. We further established that the design
with an earlobe sensor. If the heart beat goes beyond the normal value it provides chest compression of constant quality through the chest belt enclosed with motors. The mouth piece
Stability studies were carried out as per ICH guidelines for three months. The values of pre-compression parameters evaluated were within prescribed limits and indicated good free flowing property
FTIR studies did not show any chemical interaction between drug and polymer. The values of pre-compression parameters of prepared granules were evaluated the results were within prescribed limits
checked by FTIR studies and found to be intact and stable. The values of pre-compression and post-compression parameters evaluated were within the prescribed limits and showed
Stability studies were carried out as per ICH guidelines for three months. The values of pre-compression parameters evaluated were within prescribed limits and indicated good free flowing property
methane is its non-compressing nature. The biological upgrading of this single carbon source to biofuels as well as high value chemicals can bring new sustainable solutions to a number
thermodynamic parameters such as apparent molal volume and apparent molal isentropic compressibility have been calculated. The values of these parameters have been further used to derive the apparent molal volume
evaluate excess molar volume, deviation in viscosity and deviation in isentropic compressibility of binary systems and these values were fitted to Redlich-Kister polynomial equation. The mixture viscosities were…
paper was to develop a different methodology for the determination of concrete compressive strength based on measured acceleration using Artificial Neural Network (ANN). The surface of a cube was struck ... varied from…
evaluate excess molar volume, deviation in viscosity and deviation in isentropic compressibility of binary systems and these values were fitted to Redlich-Kister polynomial equation. The mixture viscosities were…
structures were calculated from stress-strain diagrams which was obtained by conducting quasi-static compression tests. Moreover, to estimate the discrepancies between the designed and the as-produced gyroid structures…
blocks. In this scheme a low bit rate still image compression is performed by compressing the indices of vector quantization and residual codebook is generated by using Modified Fuzzy Possibilistic ... that the proposed…
basic concrete characteristic which needs to be controlled is the compressive strength of concrete, the values of which are subject to various random influences, for example climatic conditions, conditions…
axisymmetric magneto dynamic (MHD) stability of a compressible fluid cylinder under the action of inertia, and electromagnetic forces is developed. A general eigenvalue relation is derived studied analytically ... high…
atom, the force of the vortex gravitation reaches its maximum value, at which the ether compresses in the center into a super dense state. The density of the substance ... collapses. At the same time, the pressure in…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.