boosting function in the proposed one. The proposed topology is simulated using MATLAB/Simulink package and implemented using MOSFET with ATmega16 controller. The simulation and implementation result shows the…
simulating the proposed solution in the MotorSolve FEM and later it is integrated with MATLAB-SIMULINK. The result observed in the proposed system is the reduction of cogging torque
used for optimizing the values of generator voltage,transformer taps and switchable VAR sources. MATLAB is used for performing optimal power flow and formulating the algorithm for optimization of reactive
power quality improvement in the grid connected hybrid power generation system is simulated using MATLAB/ SIMULINK in power system block set. The control scheme has a capability to cancel
PMSM is used to eliminate the requirement of Hall Effect position sensors. Using MATLAB/ Simulink 7.13 environment the model can be simulated to achieve a wide range of speed control
been clearly proved for achieving good performance in paralleling of these converters. A MATLAB Simulink has been developed and compared with the single and parallel schemes and also verified
equation with valve point effect and participation factor. The obtained equation is tested in MATLAB with in IEEE 30 bus 6 unit static and dynamic system with and without consideration
IEEE 30 bus systems using GA. Simulations are done by using MATLAB software. It is clear from the results that the voltage stability is enhanced well and also there
voltage regulation is done with the help of fuzzy logic controller through simulations using MATLAB / SIMULINK. In the proposed system the solar energy and wind energy is combined to produce
lifespan of the battery. The Proposed model is simulated using the tools in Matlab/Similink environment and the results are found to be better than the literature models
power point tracking algorithm. The proposed grid connected multilevel inverter will be simulated using MATLAB/SIMULINK and will be implemented in hardware using SPATRAN3A
developed for Multi-cells in a Proton Exchange Membrane fuel cell stack by using MATLAB/SIMULINK. Activation, Ohmic and Concentration losses are also considered to obtain better characteristics of fuel
along with the Asymmetric Bridge converter and proposed converters are performed by the MATLAB software. The results are analyzed and compared, which shows that the new converter performs the phase
power conversion is modelled using Space Vector Modulation technique for direct matrix converter in Matlab& Simulink. In this method, gate drive signals for the nine bidirectional switches are calculated
three phase, five level cascaded multilevel VSI based active filter with PI Controller in MATLAB/Simulink environment. The Real Power Theory control strategy is able to yield an adequate solution