Amide, Hilic, PFP, Phenyl, and RP-aqua as well WP C 18. Silica particles are of 2.6 and 1.6 μm as total and inner solid core diameters with ... importance of new generation columns with special emphasis on their…
parameters, it was found that lomustine-PLGA nanoparticles with acceptable properties could be obtained. Optimization of formulation variables to control the size and drug entrapment efficiency of the prepared…
fermentation broth is high viscosity of fermentation liquid and high content of nano-size particles. In this study, an innovative rotational circular-plate ultrafiltration membrane filter with a scraping device…
isolation is differential ultracentrifugation a method which cannot discriminate between exosome subpopulations or other particles with similar size and density. Here we have established a direct method for specific…
nanoparticles (GH-CX-NPs) were prepared by ionic gelation, and characterized in terms of particle size, zeta potential, entrapment efficiency, in vitro release, and stability. Rhodamine-labeled ... formulation stability…
particles in one square unit with the minimal neighbor distance. Sometimes this problem is with special or complex constraints. This short article will build a molecular optimization model
micro particles (micro sponges) to control the release of the drug to the skin. Naproxen micro sponge was prepared using quasi emulsion solvent diffusion method. In order to optimize ... performed. It was shown that the…
objective of this study wasto formulate and optimize PA loaded SLNs usingvarious solid lipids. The SLNs were prepared from phase behaviours of hot microemulsions-ultra probe sonication technique.The phase diagrams…
efficiency (98 ±1.45%), particle size (119.8±1.58 μm), drug loading (22.71±0.14%), % drug release (91.2%) which provide precise drug release control etc. Stability data revealed that optimized microspheres remained…
this paper, Particle Swarm Optimization (PSO) based technique for the optimal placement & setting of fuel cell in wind integrated power system is developed. By means of fuel cell optimal placement
enhancement in power system with wind energy sources, without violating the system constraints. Particle Swarm Optimization (PSO) algorithm is used in this paper for optimization purpose. The proposed method
maximum safe instantaneous penetration at transmission and distribution level for both method using particle swarm optimization(PSO). Maximum penetration is achieved by adjusting grid parameters subjected to various…
brain. The nanoparticles were successfully prepared by simple ionic gelation method using chitosanss and optimized to obtain a size under 200nm. The prepared nanoparticles were characterized for its physiochemical…
three versatile immuno-based assays for the rapid detection of GI.1 norovirus virus-like particles at low (0-3.0 μg/mL) levels: 1) enzymatic absorbance-based ELISAs, 2) a fluorescentbased ... assay time, binding…
contract time, initial fluoride ion concentration, adsorbent dosage, particle size and temperature and these conditions have been optimized for maximum extraction of the fluoride. The effect of co-ions
determined by Malvern zeta sizer. The average particle size was 100.7 nm with polydispersity index of 0.232.The zeta potential of the optimized formulation D1 was determined and found
particle size. Coefficients were estimated by regression analysis and the model adequacy was checked by an F-test and the determination coefficient (R2 ). All the responses were optimized simultaneously
nonstructural viral proteins essential for virus replication and the assembly of new virus particles. An inactivation of NS2B/NS3 protease blocks the replication of the virus. Although severalNS2B/NS3 protease…
pressure argon - 2 ATM., a stream of argon - 3 l/min; powder with particle size from 40 to 160 microns. Microhardness of the samples was measured by Vickers and accounted ... Developed the method of calculation of…
mechanoactivation of UHMWPE powder and alumina in different ratios. Optimal milling time was defined according to required morphology of alumina particles. The next stage was thermo-pressing of obtained mixed
order to produce a suitable single phase electrolyte materials. The target has been to optimize the preparation procedure towards a pure BaZr0.8Y0.2O3±δ (BZY) as well as its shaping into ... citric acid equal to 1:1.5…
aqueous solubility, poor oral bioavailability, and low therapeutic indices. The particle size and surface characteristics have been optimized to increase their circulation time in the bloodstream and to improve
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.