through thermal transitions by differential scanning calorimetry (DSC) and under thermotropic and lyotropic conditions by optical polarizing microscope (OPM) and further confirmed by small-angle X-ray scattering (SAXS
scapula. An associated omovertebral bone connecting the superomedial angle of the scapula and cervical spine was detected on CT scan. 3D reconstruction of the images allowed accurate definition ... confirmed and the…
wound sites. From scanning electron microscopy analysis, the nanofibers in each NFM are with diameters ranging from 456 to 479nm and with alignment angles within ±0.5°. The NFMs show high
SrTiO3 and (110) LaAlO3 substrates. Substrates were vicinal with off angles up to 20°. X-ray diffraction j - y scans demonstrate that films grown on a flat substrate are composed
Rarely, it may arise from petrous bone in cerebellopontine angle producing sensorineural hearing loss. This article describes computed tomography scan (CT scan) and magnetic resonance imaging (MRI) findings
chemical properties of the synthesized samples were studied using Small Angle X-ray Diffraction (SAXRD), Transmission electron microscopy (TEM), Scanning Electron Microscopy (SEM) and nitrogen adsorption–desorption…
nanosilver/polyvinylalcohol layer. The membranes were characterized by scanning electron microscopy (SEM), Fourier transforms infrared (FTIR) spectrophotometer, contact angle, with membrane mechanical properties. The…
compared against airborne laser scanning (ALS) based digital elevation models. Due to the dynamic topography of the sites under investigation, a wide range of slope angles could be investigated. ICESat
lumbosacral regions. In the present study, the authors attempt to determine lumbar facet angles and incidence of facet tropism in adults. Materials and Methods: 54 patients (30-50 years) admitted ... using CT scan…
total of 200 CBCT scans (400 sides of mandible) were acquired; the deepest regions of the submandibular gland fossa and the concavity angle between the alveolar crest and the upper
investigated using contact angle measurements while the electrical conductivity of the polymeric solutions and the thermal properties of the fibers were also evaluated. Differential scanning calorimetry (DSC) was used
once again took radiography (all patients) and a CT scan (main study group). The aim is to see if the angles have been corrected after surgery. Finally, a comparison
once again took radiography (all patients) and a CT scan (main study group). The aim is to see if the angles have been corrected after surgery. Finally, a comparison
properties of the coatings were characterized by optical microscopy, scanning electron microscopy, UV-VIS-NIR spectrophotometer and water contact angle method. The results show that the coatings obtained are homogeneous
Infra Red Spectroscopy (FTIR), Ultaviolet-Visible Spcetroscopy (UV-Vis), Small angle X-ray Scattering (SAXS), X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM). The…
extent of nanoparticle dispersion was observed through scanning electron microscopy (SEM), transmission electron microscopy (TEM) and wide-angle X-ray diffraction (WAXD), respectively. The molecular level interactions
these blends by various techniques such as optical microscopy, scanning electron microscopy, transmission electron microscopy, atomic force microscopy, and small angle laser light scattering. The dynamics of phase…
finger tips of each glove was analyzed under the scanning electron microscope (SEM), and were tested for changes in contact angle and tensile properties. Results: Exposure to cement caused
triple layer membranes were confirmed by using Scanning Electron Microscope (SEM), thermal gravimetric analysis (TGA) and water contact angle measurement. FTIR spectra of surface modified PAN membrane filter exhibits
chloride. Membranes were characterized in term of morphology by scanning electron and atomic force microscope, the hydrophilicity/hydrophobicity by contact angle measurements, tensile strength at maximum and the tensile…
mandible and Mandibular Angle Fractures (MAFs) in an Iranian population. This retrospective study was conducted on 3D Cone-Beam Computed Tomography (CBCT) scans of 118 patients between
Shear bond strength, bond failure, and scanning electron microscopy analysis of a new flowable composite for orthodontic use. Angle Orthodontist 75(3):410-5. 4. Schleyer T L (2000) Nanodentistry
seconds (s)]. The average contact angle (CA) measurements and surface changes were recorded via a tensiometer and scanning electron microscope (SEM) respectively. According to the results, the argon plasma
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.