field, and an important basis of evaluation of development effect. Because the water content of oil well an item is all oilfield laboratories must analyze project, which is the detection ... development, that is the…
Physico-chemical parameters for water samples collected from 10 borewells, dugwells from different places of Phulambri Taluqa, were measured. The water samples were shown to be good computation of correlation
molecularly imprinted solid-phase extraction (MISPE) as the sample clean-up technique combined with high-performance liquid chromatography (HPLC). The water-compatible molecularly imprinted polymers (MIPs) were prepared…
using ground water as source of drinking water. In the present study, the ground water samples were collected from selected sampling stations around the Late Ku. Durga K. Banmeru Science
serious issue since there are virtually no safety barriers before water consumption. Accordingly, developing monitoring (sampling) system which is capable of increasing the level of protection for consumers in case
geosmin (GSM) was developed. The preliminary procedure involved purging a 25 mL water sample, at 80°C for 11 min, with helium gas, and trapping onto a Tenax sorbent. Target ... conditions. Preliminary results indicate…
attempt has been made to assess the levels of radon concentration in some drinking water samples and radon exhalation rate in soil samples belonging to some locations of Kapurthala district
from the raw sample stage through sample preparation to the final analysis of reduced sample residues by capillary gas chromatography and GC/Mass Spectrometry. A variety of target analytes were ... application of…
Trace metal analysis in natural waters is crucial for understanding environmental health and assessing anthropogenic impacts. Accurate measurements depend significantly on proper sampling and storage techniques to…
sampler for in situ calibration has been demonstrated to improve the quantitative nature of water concentration estimates. Hydrophobic polycyclic aromatic hydrocarbons (PAHs), though they occur at significant levels…
again between the present samples and samples of the same alloy but oxidized in dry air, the differences between oxidationwith this higher water vapour content and oxidation with a less
confidence level. The validated method was applied to analyse FNT residues in real water samples without extraction, purification, or addition of supporting electrolyte, as the natural buffering capacity ... samples was…
drinking water. It is a cost-effective and efficient technique for detecting bromate in water samples at sub-ppb levels. By using a pre-concentration column, higher sensitivity ... quantified. This could be…
details of ponds. In order to assess the quality of pond water, 26 water samples from different ponds were collected and the physicochemical parameters ... pond water were recorded in situ. The TDS values of the samples…
adsorption, degradation and leaching of metolachlor in soil samples from 10 locations, is covered in this paper. The batch equilibrium technique was used to conduct the adsorption experiments. Solid-phase ... This…
years. We collected sociodemographic and environmental data using electronic questionnaires and analyzed stool samples using direct smear, formalin-ether concentration (Ritchie method) and Kato-Katz techniques…
selected from three agro-ecologies in the district, and the sampling procedure was multistage sampling techniques. The data was analyzed using SPSS software, and significance differences among the means ... Crop…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.