Conference abstract · 2018
Conference abstractPublished 21 Sep 2015
Nanoparticles characterization for biodiesel in internal combustion engine
University of Malaya, Malaysia
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
A comparative morphological analysis was performed on the exhaust particles emitted from a DI diesel engine using different blending-ratios of palm biodiesel. In this study, several operating condition modes have been set under two constant loads 25% and 50% and constant speed of 2420 rpm. Biodiesel has selected due to its properties to reduce the amount of particulate matter from the exhaust emission of the engine. It has been observed by this experiment that particulate matter & particulate matter concentration are reduced with respect to diesel fuel at 25% load condition. The particle size for each fuel blends increased with an increasing the engine load. Palm biodiesel are less effective for formation of soot precursors than the diesel fuel combustion. The amount of volatile material produced from the biodiesel samples is slightly less than the volatile material produce from the diesel fuel sample. Thermogravimetric Analysis (TGA) showed that the amount of volatile material in the soot from biodiesel fuels was slightly lower (10.8%) than that of diesel fuel. On the other hand, the amount of fixed carbon from the biodiesel samples was slightly higher than that of diesel fuel. Similarly, Ash content increased with the increasing biodiesel content in the fuel blends. The amount of carbon percentage emitted from the diesel engine exhaust using bodiesel increased (by 0.85% to 10% respectively) with an increasing ratio of biodiesel to diesel fuel, while the metal composition of the exhaust gases was increasing at between 4.8% to 26.5% respectively. Finally, comparing between SEM images of diesel, B20 and B40, was found more particles in diesel exhaust and it was gradually decreased with an increasing biodiesel concentration in the diesel fuel.
Subjects
NanotechnologyAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Research article · 2009
Preparation and characterization of cobalt oxide nanoparticles via solution combustion method
Review article · 28 Jan 2025
A Review: Synthesis and Characterization of Transition Metal Oxide Nanoparticles and their Application for Removal Organic Pollutants and Biodiesel Preparation
Conference abstract · 1 Dec 2016
Characterization of wear mechanisms occurring on piston ring and cylinder bore of the internal combustion engine
Short communication · 29 Sep 2020
Studies on the effects of nano-additive based biodiesels on low- and high-pressure injection assisted diesel engine performance, combustion and emission characteristics
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- SubjectNanotechnology
- BylineArticles whose byline prints “Mohammad Ashraful Alam”
