Conference abstract · 21 May 2018
Conference abstractPublished 14 May 2018
Practical approaches to energy efficiency improvement in SiC-based ceramics processing
D. Mendeleev University of Chemical Technology of Russia, Russia
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Statement of the Problem: Glass and ceramic industries fall into the category of energy-intensive industries and since 2014 when Integrated Pollution Prevention and Control was introduced in Russia these sectors have been closely monitored with regards to resource efficiency and environmental performance. Methodology & Theoretical Orientation: Traditional sub-sectors including tile and brick manufacturing in 2003-2013 participated in pilot projects intended to evaluate possibilities of implementing Best Available Techniques (BATs) in Russian industries. Based on the results of these projects BATs have been identified and national Information and Technical Reference Books developed. In manufacturing technical ceramics existing sector-specific BATs comprise mostly emissions control. However, considering materials for advanced applications such as alumina, zirconia or carborundum, where these levels are determined by strict process parameters, a generally accepted practice is to reduce energy consumption by adjusting firing temperature. This allows to suggest candidate BATs: batch composition adjustment, the use of eutectic sintering aids, and liquid-phase sintering. Findings: The present research addresses a combination of these techniques in production of SiC-based structural ceramics including selection of additives based on their physico-chemical properties (melting point, surface interaction) and the use of pre-fabricated sintering aids with enhanced reactivity. The effects of the additives on sintering behavior, phase composition, microstructure, and mechanical properties were studied. Conclusion & Significance: The combination of ultrafine SiC with 25 vol. % of a eutectic sintering aid in MgO-Al2O3-Y2O3 system allowed to produce ceramics with bending strength of 450 MPa, fracture toughness of 4.0 MPa·m1/2, and elasticity modulus of 380 GPa. Sintering temperature for this material didn’t exceed 1900 °C, which makes this technique practically suitable to reduce emissions and the impact on the environment. This research was carried out with financial support from the Ministry of Education and Science of the Russian Federation under State order, contract No. 10.6309.2017/BCh.
Subjects
Energy & PowerMaterials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Similar by topic
Conference abstract · 9 Sep 2017
Microstructure and surface properties of Ti-6Al-4V cold spray coated with SiC-based cermet
Conference abstract · 29 Feb 2016
Laser coating of Ti-6Al-4V with SiC-based cermet
Conference abstract · 25 Jul 2016
Energy-efficient sintering of ceramics
Conference abstract · 12 Sep 2016
Analysis and simulation guided processing of hierarchical porous and multi-layered ceramics for energy applications
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- SubjectEnergy & Power
- SubjectMaterials Science
- BylineArticles whose byline prints “Maria Vartanuan”
