label. The method was qualified over the calibration curve range 0.168 to 100.8 pg/mL (0.025 to 15.0dpm/mL) using linear regression and 1/y² weighting. Within-run relative
Calibration curves were plotted using the absorbance and concentration of the mixed solutions of two drugs. The drugs; Amlodipine Besylate and Candesartan Cilexetil were found to be linear ... measuring the absorbance…
Terbutaline sulphate followed the linearity concentration range 4-24 mcg/ml for Theophylline and 2-12 mcg/ml for Terbutaline sulphate by these methods. Standard calibration curve for both Theophylline ... method B. The…
straight line relation between absorbance and amount of mifepristone is A = 0.0242C+ 0.0003. The linear plot shows that Beer’s law is obeyed in the range ... experimental data of the calibration plot is 0.9997. The…
Desogestrel. Linearity for detector response was observed in the concentration range of 10-150% of test concentration. Correlation coefficient (r) for calibration curve was found to be 1.0. Retention times ... studied…
voltammetry procedure 1 showed higher epinephrine slope calibration curve than the others nanoparticles deposited by constant potential and cyclic voltammetry procedure. Higher linearity and stability was showed for…
treated potable waters, was undertaken. Using three calibration methods, the method was found to be sensitive (LOQ=2 μg/L), over the linear range 10-30 μg/L. The overall
antibody and a SPR technology. The immunosensor was calibrated using purified full length PB1-F2 protein. Itdetected PB1-F2 with the linear range extended from 10 to 500 nM, repeatability
determination of CC by the bivariate calibration depending on simple mathematic algorithm which provide simplicity and rapidity. The method showed good linearity in the range
recently the FDA, a weighted 1/x2 linear regression model ranging from 0.25 to 10.35 mg/L was selected as the simplest calibration model that maximized the accuracy all over
target strand was directly accomplished by calibrating the quenched ECL signals. Under optimal conditions, the decreased ECL intensity had a good linear relation upon the logarithm of target DNA concentration
taken as 271 nm. Linearity for detector response was observed in the concentration range of 50 to 150 % of test concentration. Correlation coefficient (r) for calibration curve was found ... studied was less than 2. The…
maximum ratio of 1.10. Calibration of N-Flex-Pave-calculated and Design Curve-measured results were compared using linear regression analysis and the results were found to be good with
trihydrate in the dosage of 250mg.The calibration curves were formed in the concentration range of 10-80μg/ml. The correlation coefficient, linearity, LOD, LOQ and RSD values were found
Citicoline Sodium and calibration curves were plotted as dA/dλ versus concentration, respectively. The method was found to be linear (r2>0.999) in the range
laser beam. Calibration curves were carried out immersing the probe in different Glu concentrations (50-500 uM) a linear regression analysis of 0.998 was obtained. The following experiment was carried
error prone because of calibration based value in pure sucrose solution. It deviates in technical solution and does not maintain linear relationship on dilution. Regarding Pol, it is affected
Diacerhein and calibration curves were plotted as dA/dë versus concentration, respectively. The method was found to be linear in the range of 10-50 ìg/mL for both
variables loadings produced by principal component analysis (PCA), characteristic wavelengths were acquired and linear discriminant analysis (LDA) models were built on the basis of them. Findings: The results showed…
parameter hybrid functional (B3LYP) and 6-31+G** basis set. By using the multiple linear regression (MLR) technique several QSAR models have been drown up with the help these calculated ... stepwise regression method…
respectively. Method had a wide linear range over 1.25-100 mg/kg range with regression coefficients greater than 0.999 obtained over seven calibration levels. Precision measured in terms of repeatability
Statistical analysis techniques, such as Multiple Linear Regression (MLR), Partial Least-Squares (PLS) Regression and Neural Network (NN) were carried out to calibrate and validate QSAR model. Leave
less than 5 %. A six-point calibration curve (determined over the range 0.5 μg/ml to 50 μg/ml of IPTS) of good linearity with a correlation coefficient
laboratory was used for the calibration of the models while some parts were used for the verification. The verification was assessed using linear regression coefficient of correlation and average relative
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.