sample inlet pathway before plasma. Additionally X-cone in the skimmer and Jet sampler cone combination dramatically increased Pu signal by a factor of 2~3. Detection limit and precision
adjusted with orthophosphoric acid), detection wavelength used by Waters HPLC Auto Sampler, Separation module 2695, UV detector 2489, Empower-software version-2. The retention times were found
PM2.5-10 (coarse) were collected on nuclepore polycarbonate filters using a low volume GENT sampler (Schlumberger Model: M250) equipped with double staged stacked filter units. A total of 192 samples were
detection at 280 nm. 10 μL volume of sample was injected by the auto sampler. Separation was completed within 3.82 ± 0.03 minutes. For both drugs linear was obtained over
fine particles (PM1.0-2.5). Air sampling was carried out with the cascade impactor “Dekati PM10 sampler”. Filters of the samples were analyzed with the Limulus Amebocyte Lysate (LAL) assay. The amount
blood, till 3 freeze/thaw cycles, 104 h in auto-sampler at 6°C. This proposed method can be used for measurement of reliable concentration for dossier submission
PM2.5 at Pune city in Maharashtra, India were measured with the help of PM2.5 sampler and chemical characterization of Pb and Cd was done to determine the concentrations
relative humidity was gathered to calculate absolute humidity. Air samples were collected using NIOSH samplers. Fomites were collected from objects (e.g., markers, wooden blocks) wrapped in 25% cotton linen paper
load of roadside urban suspended particulate matter in Amritsar city, using high volume sampler and metrological parameters were procured using underground site on same days of sampling period. This
method for the determination of EAs in human urine using a static headspace generator sampler coupled with gas chromatographyâÂ?Â?mass spectrometry (HSâÂ?Â?GCâÂ?Â?MS). Twelve significant
impact on medium in the petri dish with a bio-collector (air sampler). The cultures obtained on Sabouraud medium are identified by filamentation test and Achlamy sporulation test for yeasts
procedures, except the last rinse water of a process was collected with a water sampler and tested on ATP. Data from negative controls and empty cycles were also obtained
study was conducted in Arafat area, air samples were collected using mini volume Hi-sampler for 24 hrs once in a week through summer and autumn 2015 including Hajj season
spotted on precoated silica gel 60 F254 plates using Camag Linomat V auto sampler. A concentration range from 100–700 ng/spot for both drugs was used for calibration curve
hundred and twenty sediment samples (30 per quarter) were collected using Van Veen grab sampler. The sediments were extracted and cleaned up using standard methods. The levels of PCB congeners
ponds at each date were taken between 0900-1100 h with a column sampler, stored in an insulated sealed cooler, and returned to the University of Arkansas at Pine Bluff
obtained to the regulatory limits. The particles were captured using SKC Air Check Gravimetric Sampler. The sampling was done three times a week for six months between October
main industrial activities. The study was carried out using different gas analyzers and samplers. From the statistical analysis it was found that, there were extremely high values of black carbon
Fagaceae pollinosis. Method: There are institutions in fifteen locations monitoring airborne pollen by Durham sampler in Japan between the latitude of 30 to 40 degrees north. At each institute daily
ponds of a fish farm were collected in February 2014 with a single core sampler and were analysed to measure the concentrations (mg/Kg DW) of Zinc (Zn), Lead
maintained at 45°C. Injection volume was set at 1 μL with an auto sampler maintained the temperature at 10°C. Detection of all the components was monitored
flow rate of 1 ml/min were used, the auto-sampler injection volume was 15 μL, and metronidazole benzoate was used as internal standard. The retention time for carbamazepine
detector, by keeping the column oven at room temperature while the auto-sampler temperature was maintained at 4°C. A fractional factorial design has been applied for the optimization
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.