studieshave reported on the influence of SO3 on Cu-loaded Chabazite (Cu/CHA) catalysts. Discussion: The Variation of the CHA Structure under SO3 Poisoning: It is normally accepted that
mechanism. In this work different molar ratio of Au/Pd catalysts were synthesized [5] with a final metal loading of 10 wt% on activated carbon and the influence of bimetallic ... showed the lowest H2O2 productivity for…
loaded into the zeolite sample which was enriched and calcined previously, by ion exchange method. The prepared Ni/zeolite, Fe/zeolite catalysts were identified as clinoptilolite type zeolite from ... down during the…
depends on the severity of the operation, of the quality of the load and the type of catalyst. The catalyst used in the catalytic process of reforming is a very
supported by pumice silica as solid base catalyst. Pumice silica catalyst was activated by loading alkali metal ions to its surface via an ion-exchange method. Response surface methodology ... biodiesel production…
Significant points on comparison platforming catalyst performance include: 1) UOP’s R-56 reforming catalyst achieved 96 RON reformate production ability, long cycle length, and good stability of the yield…
catalyst. To promote activity and selectivity and find the optimum loading percentage and its effect on catalyst performance, Manganese (Mn) has been added to the Co/CNT catalyst. Samples were
amount of noble metal loading while the high reactivity is still retained. In order to fulfill this demand, high dispersion of noble metal-containing catalyst on different cheap and conducting ... this work, noble metal…
activity of the Co 3 O 4 /MCM-41 catalyst strongly depended on the amount of Co 3 O 4 loading. The influence of alkali cation promoters ... activity of the most active catalyst in the Co 3 O 4 / MCM-41 series, i.e. with…
ZSM5 zeolite was impregnated with different KOH loadings (15 wt.%, 25 wt.% and 35 wt.%) to prepare catalysts used in the biodiesel production via transesterification of refined sunflower ... loading showed the best…
catalyst samples, with increasing nickel loadings of 4 to 29 wt%, were prepared by impregnation of different nickel precursors on SBA-15 mesoporous silica support. A modified sol-gel method ... loadings were obtained…
bran oil products. When rice bran oil is thermally decomposed using different loads of calcium oxide as catalyst, it can be used as a diesel fuel. We also analyzed ... alternative fuels as rice bran oil and their ester…
phase at optimal conditions. Tuning the time, temperature and loading parameters enable production of different oil qualities. Heterogeneous catalysts can be used to increase oil yields relative to solid products
with activities higher than its single metal counterparts. A suite of catalysts with a range of metal loadings was made and the materials were characterised using high resolution STEM with ... three electrode cell to…
Reduction of noble metal loading and increase of specific activity are omnipresent challenges for oxygen evolution catalysts in proton exchange membrane (PEM) water electrolysis. The latter are often tackled
evaluation of photo catalytic activity of Ag-TiO2 is reported. TiO2 catalysts with 2, 4, 6 and 8% loading of Ag were prepared by green methods using Azadirachta indica leaves ... TiO2 exhibited the best catalytic…
situ reduced the Cu+2 ions forming a Cu NPs-loaded hydrogel, which proved an excellent catalyst as evidenced by the reduction reaction of 4- nitrophenol. We believe that
situ hydrothermal process and were subjected to a simple ion loading reaction for preparing the suitable catalyst material for carbon nanotube-filters. The carbon nanotubes were grown directly upon biomorphic
higher than those from spark ignition (SI) engines, especially at low engine load when the EGR rate or the residual gas required to control NOx emission are elevated. Toxic chemicals ... HCCI stoichiometric and SI…
dehydrogenation catalysts containing tin, indium, iron and litium as promotors. Several catalysts were prepared with changes in Pt loading (0.1, 0.3, 0.5) and employed in the dehydrogenation reaction of higher…
activity and selectivity strongly depend on the loading amount and grain size of Ag. The catalysts with small grain size of Ag had higher activity than those with big grain
cleaner gas, respectively. According to our results, with increasing the loading mass ratio of Fe to MgO, the catalyst nanoparticles size is increased as a result of which the diameter
situ hydrothermal process and had been subjected to a easy ion loading response for making ready the suitable catalyst fabric for carbon nanotube-filters. The carbon nanotubes were grown directly
loadings of ruthenium supported on different metal oxides and large quantities of inorganic salts, organics or ionic liquids. This results in a difficult four-phase reaction composed of water, catalyst
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.