surface morphology was studied with scanning electron microscope (SEM). The kinetic, equilibrium modeling, thermodynamic parameters, and adsorption characteristics have been studied. The adsorption characteristics and…
ions such at Fe3+, Cu2+, Ni2+, Co2+, Zn2+, Cd2+ and Pb2+. A batch equilibrium method adsorption chromatography was employed in the study of the selectivity of metal ion uptake involving
Kenaf-dust filled chitosan biocomposite was prepared for the adsorption of metal ion. The adsorption property of the biocomposite towards Cu2+ ion was evaluated. Various factors affecting the uptake behavior ... initial…
high (77%) and for pH greater than 9.0 decreased (40%). Adsorption kinetics and equilibrium studies were carried out, fitting the equilibrium data to both Langmuir and Freundlich models. Batch adsorption ... that the…
samples were agitated on horizontal shaker for 30 h. The time to reach adsorption equilibrium was obtained from a kinetic study performed over 72 h. The adsorption kinetics of divalent ... data showed that diffusion…
sorption versus desorption after infinite time. In dyeing process, the investigation of the equilibrium dye distribution between the dye bath and the substrate is very important. The thermodynamics of dyeing ... with…
this paper the solute transport in a fractured-porous medium is considered with equilibrium adsorption. One the basis of numerical results an influence of adsorption on solute transport characteristics
adsorbent was identified by using scanning electron microscope and X-Ray diffraction data. The adsorption equilibrium data have been analyzed using Freundlich and Langmuir isotherm model. Equilibrium adsorption data…
intra-particle diffusion. Freundlich and Langmuir isotherm models were applied to the equilibrium data. The adsorption capacity (Qm) obtained from the Langmuir isotherm plots with temperature variation study showed that
number of adsorbed molecules per site (n), density of receptor sites (Nm) and equilibrium concentration of adsorptive in the solution at half saturation (C1/2) were estimated by fitting ... found to satisfactorily fit…
ionic strength and temperature. Langmuir and Freundlich isotherms were used as the model adsorption equilibrium data. The constants of Langmuir and Freundlich models are obtained from fitting the adsorption equilibrium…
were used as adsorbent and support matrix for the batch equilibrium adsorption-biodegradation studies; while different initial naphthalene concentrations (10 – 50 mg/l) and pH (5, 7 and 9) were ... used for the batch…
increase in adsorption with increase in pH was obtained. The adsorption process was found to be rapid as equilibrium was attained within 50 minutes. The result showed an increase
adsorption of Ni (II) and Co (II) onto HPMMA was investigated. Equilibrium studies show that the adsorption follows both Langmuir and Freundlich isotherm model. Kinetic studies show that the adsorption
This study investigated the moisture adsorption characteristics of sprouted Bambara groundnut (Vigna subterranean). The adsorption isotherm for sprouted Bambara groundnut was determined and studied at room temperature…
adsorption process of Waste Tea Leaves (WTL). The optimum pH (4.00) and the adsorption equilibrium could be obtained by centrifuging for 180 minutes at RT and 140 RPM. The optimum ... spectroscopy analysis showed that…
Morris intra-particle diffusion models were tested to describe the adsorption process. Kinetic parameters, rate constants, equilibrium sorption capacities, and related correlation coefficients for kinetic models were…
adsorption phenomenon was investigated by using HPLC, UV-VIS spectrometer and Fluorescence spectrometer. The equilibrium adsorption isotherm was analyzed by using Langmuir modeling. Boronic Naphthalene (B-Nap-Cn) probe
temperature. The time required to obtain the maximum adsorption was found to be two hours at 298 K. The equilibrium data were described by Freundlich, Langmuir and Tempkin isotherm models
were used to fit the experimental data. Freundlich isotherm model matched very well the adsorption equilibrium data in the studied conditions. Several kinetic models were applied to fit the adsorption
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.