amplify the signal power. The main reasons why we used EYDFA were the possibility of doping the fiber with high gain, pump efficiency and the broadening of the absorption band ... which offers greater flexibility in…
describes the structure and working principle of diaphragm pump design, Hydraulic system state equations are derived by power bond graph, the dynamic characteristics of hydraulic components or systems are simulated
obtained. Laser characteristics such as output, signal-to-noise ratio, linewidth, threshold pump power, pumping slope efficiency and side mode suppress ratio are measured. One example of fiber laser characteristics…
investigation has also been done on the use of the combined wind power with pumped storage systems (WPS) to enable the system to exploit the curtailed wind energy & surplus ... installed capacity and replace the peak…
Laser characteristics such as output power, optical signal-to-noise ratio, laser linewidth, threshold pump power and pumping slope efficiency are measured. An example characteristic ... ratio, quantum efficiency and…
polarization. The disturber performance was evaluated in terms of concentration polarization factor versus consumed pumping power and pressure drop, with a larger factor meaning a more serious concentration…
eventually replace the fossil fuel source as the availability of latter declines. A solar powered pump is a normal pump with an electric DC motor. Solar powered pumps will naturally
Optically pumped semiconductor (OPS) laser has unique advantages over its electrically pumped counterparts. The most prominent one being power scalable without sacrificing the beam quality. Lasing in the fundamental…
environmental pollution are some of the main reasons for their widespread introduction in electrical power systems. The development and usage of these alternative energy technologies are still restricted. Solar energy…
bandwidth of an optically pumped semiconductor laser (OPS) is determined by the bandwidth of the material gain, the bandwidth of the longitudinal confi nement factor (LCF) and the bandwidth ... cavity (low OC), where…
dependences of output power from active media length and pumping power demonstrate three features: a smooth growth at low pumping power or at small active length, then exponential growth
used in the optical transmission systems because it has the maximum gain and low pump power and its performances are better in comparison with other similar amplifiers. Performance ... different configuration techniques…
sensitivity analysis is carried out for a double effect absorption heat pump in parallel flow powered by biogas, using ChemCad software. The system uses 350 kg/h of LiBr ... cooling condenser temperature equal to 277 K…
rate (BER), gain flatness and noise figure of EDFA through optimized fiber length and pump power. A commercial software, known as ‘Optisystem’ is used in this project for implementing
grating (TFBG) as cavity ends. Several characteristics such as the gain fiber length, threshold pumping power, pumping efficiency and side-mode suppression ratio (SMSR) are studied. The wavelength tuning function
very cost effective and efficient pump sources for fiber lasers. They consist of arrays of diode lasers which generate hundreds of watts of power, that is are coupled into ... broad area lasers at 980nm are used as the…
leaky modes excitation increment can improve considerably the efficiency of side pump couplers for high power fiber laser will be presented here. It is important to mention that the scaling ... lasers depends largely on…
pipe and thermal resistances are obtained in different power. The pressure drop and pumping power are measured in different Reynolds number. The experiments are conducted for pure water ... size and concentration of…
above 100 W CW lasers as the laser crystal cannot withstand the very high pump power density and the get fractured under thermal stress. Therefore, obviously side pumping ... absorption length and multiple reflection of…
operation of gear pumps and the effects of several variables on their efficiency. Through the analysis of many graphs, including “discharge vs. head, discharge vs. input power, discharge vs. efficiency ... able to…
equations with the (SBS) in the linear cavity. The numerical results show that the pump power, laser power and stokes powers propagating along axial positions are obtained by using ... fiber laser model without…
For authors and organisers
Publish, present and keep up with your field
Find the right journal for your paper and submit your manuscript.