Scholars Central

Conference abstractPublished 14 Sep 2015

Utilizing thermal spray coating technology to avoid PWHT after retention of nominal wall thickness through weld build-up on DGA stripper column

Authors: Abdullah Alali

Saudi Aramco, KSA

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

The paper presents one an experience in utilizing thermal spray coating technology on top of weld build-up of CS pressure vessel eroded shell. The vessel is under lethal service and had severe erosion on some of its internal surface of the shell. According to ASME PCC-2 (Repair of Pressure Equipment and Piping), Article 2.11, PWHT is required after retention of nominal wall thickness through weld build-up. However, heat treatment of this vessel was infeasible due to stability analysis results that show instability of the column during heat treatment. Therefore, thermal spray coating was used as a substitute to PWHT.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • SubjectMaterials Science
  • BylineArticles whose byline prints “Abdullah Alali”