Scholars Central

Conference abstractPublished 5 Mar 2018

Investigation of 3D printable biocompatible orthodontic polymers

Authors: Melinda Szalóki

University of Debrecen, Hungary

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Biocompatible MED620 and MED610 polymers are 3D printable materials used mainly in oral surgery and orthodontics. Researchers have reported that MED610 significantly reduced the cell numbers of keratinocytes, even in non-direct contact. The purpose of this study is to investigate the effect of different surface manipulations on cell proliferation, surface specific oligopeptides regarding MED610 and to compare to MED 620 and MED610 regarding degree of conversion (DC), polymerization shrinkage (PS) (Stratasys, USA). The MED610 and MED620 samples were printed by Objet30 OrthoDesk (Stratasys, USA) 3D printer. In cell proliferation study osteosarcoma (SAOS-2) and dental pulp stem cells (DPSC) were used. The surface manipulation was done by two methods of support material removal. 7-mer oligopeptides was used to determine surface specific peptides based on New England Biolabs protocol. The PS of polymers was measured based on Archimedes’ principle by an analytical balance (Adam PW 254, UK). A Nicolet 6700 Fourier Transform Infrared spectroscope (FTIR) (Thermo Electron Co. USA) in attenuated total reflectance (ATR) mode was used for DC measuring. The surface treatment has an effect on cell proliferation and surface specific oligopeptides. The PS of MED620 and MED610 photopolymers were 7.56 V/V% ± 0.12 and 8.17 V/V % ± 0.24, respectively. The DC of MED620 and MED610 samples 93.34 % ± 2.66 and 97.76 % ± 1.31, respectively. Based on the results of the study it was found that the chemical modification of polymer surface influence the numbers of the attached cells, sequence of surface specific peptides and the physical properties i.e. polymerization shrinkage and degree of conversion that can be related to the different application and composition of the 3D printable biocompatible orthodontic polymers. The work is supported by the GINOP-2.3.2-15-2016-00011 and GINOP-2.3.2-15-2016-00022 projects. The projects are co-financed by the European Union and the European Regional Development Fund.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • SubjectChemistry
  • SubjectDentistry & Oral Health
  • BylineArticles whose byline prints “Melinda Szalóki”