Research articlePublished 17 Jun 2015
Effect of Friction Stir Processing on (2024-T3) Aluminum Alloy
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
In this work, friction stir process (FSP) was used to enhance surface properties of AA2024-T3 alloy. The effect of friction stir shoulder rotation in addition to its pressing effect on surface topography and mechanical properties was studied. Samples were FS processed with a flat pinless cylindrical shoulder of 10mm diameter with a constant rotational and travel speeds 945 rpm and 85mm/min respectively. Results show that processed layer thickness of about 45 μm was produced after FSP. Microscopic examinations (OM and SEM) revealed refining grain size of second phase particles as a result of mixing effect of the tool. XRD results show changes in the height and width of the strengthening phase θ(Al2Cu) peaks, while EDX results show that Al and Cu created at another energy (KeV) compared with those that are not in phase before FSP. The maximum hardness increment is about 40-45% and the maximum value obtained at the surface is 190Hv compared to 130Hv before processing. A little bit increase was recorded in yield and tensile strengths by an amount of 15% and 9% respectively after FSP.
Subjects
EngineeringAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalInternational Journal of Innovative Research in Science, Engineering and Technology
- SubjectEngineering
- BylineArticles whose byline prints “Fadhel A. Hashim”
- BylineArticles whose byline prints “Raid K. Salim”
- BylineArticles whose byline prints “Basheer H. Khudair”