Scholars Central

Research articlePublished Feb 2015

Influence of Metal (Aluminium) Layer Thickness in Glare

Authors: Jayaprakash.L, Ranjithkumar. K, Pradeep Kumar.S.L

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

The ductile resistance of the fibre-metal laminates has been analysed experimentally on three various different FML laminates that is made up of aluminium sheets of three different thickness namely 0.2mm, 0.3mm & 0.4mm. Tensile and flexural tests on the specimens were carried out to analyse the ductile behaviour of the FML laminates. Stress vs strain curve for tensile and load vs displacement curve for flexural test. The respective parameters like ultimate stress, young’s modulus, longitudinal strength, flexural failure, flexural modulus, etc., are calculated from the plots. The results were compared with each other to evaluate what is the impact of metal layer thickness in the FML plates. There is good variation between the experimental results is obtained. Finally the best fiber to metal ratio is found out and the result is justified.

Subjects

Engineering

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalInternational Journal of Innovative Research in Science, Engineering and Technology
  • SubjectEngineering
  • BylineArticles whose byline prints “Jayaprakash.L”
  • BylineArticles whose byline prints “Ranjithkumar. K”
  • BylineArticles whose byline prints “Pradeep Kumar.S.L”