Conference abstractPublished 27 Dec 2017
3D printing graphene oxide geopolymer nanocomposites and its structural failure model
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Preparation of inks with proper viscoelasticity is the key pre-requirement for extrusion based 3D printing. Here, extrusion based 3D printing Graphene Oxide (GO)/Geopolymer (GOGP) nanocomposite was reported for the first time. We found that, the addition of GO in geopolymeric aqueous mixture (alumio-silicate and alkaline-source particles) dramatically changes its rheology properties and enable the 3D printing that cannot be realized solely by geopolymer, indicating a strong GO/ alumio-silicate interaction. We proposed a model, in which a water layer is laminated between GO and alumio-silicate, based on the facts that both of GO and alumio-silicate are hydrophilic and negatively charged, to account for such phenomenon. The chemical and microstructure analysis showed that the GO nanosheets anchor themselves around and encapsulate individual geo-polymer grains to resist being pullout and at the same time, form a continuous 3D network throughout the whole nanocomposites, which was proved by selective etching of geo-polymer and left behind free-standing porous GO aerogel. Therefore, not only the mechanical properties of geo-polymer were significantly increased by GO, but also very high electrical conductivity was obtained after sintering and endow our 3D printing nanocomposite among the highest conductive ceramic nanocomposites. In addition, we found that, enhancing mechanical properties at material level by employing large GO nanosheets, will inevitably switch failure model from stretching/compression to buckling instability, thus limit the fully exploitation of material properties and thus in turn, structural performance. This finding suggests the local modification of 3D printed structures, especially weakening the rotational stiffness of nodes, is critical for the realization of 3D printing superstrong cellular solid.
Keywords
Subjects
Materials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Conferences in this field
Upcoming conferences in this field.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalResearch & Reviews: Journal of Material Sciences
- SubjectMaterials Science
- BylineArticles whose byline prints “Jing Zhong”