Scholars Central

Conference abstractPublished 20 May 2019

Thermal and thermomechanical properties of graphite flakes and carbon fibers reinforced aluminum matrix composites

Authors: Jean Francois Silvain

ICMCB-CNRS, France

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

Today, the microelectronics industry uses higher functioning frequencies in commercialized components. These frequencies result in higher functioning temperatures and, therefore, limit a component’s integrity and lifetime. Until now, heat-sink materials were composed of metals which exhibit high thermal conductivities (TC). However, these metals often induce large coefficient of thermal expansion (CTE) mismatches between the heat sink and the nonmetallic components of the device. Such differences in CTEs cause thermomechanical stresses at the interfaces and result in component failure after several on/off cycles. To overcome this issue, one solution is to replace the metallic heat sink materials by a metal matrix composites (MMCs), specifically, carbon-reinforced aluminum matrix (Al/C) which exhibit optimized thermomechanical properties. Moreover, due to his low density, 2.7 g/cm3, Al has a high specific thermal conductivity (TC divided by density) and low cost which are great advantages in terms of the fabrication of mobile electronic devices for automobile or aeronautic industries. Carbon fibers (CF) and graphite flakes (GF) were preferred to diamond particles because of their low coefficient of thermal expansion (CTE), high thermal conductivity (TC), and a good machinability. These reinforcements will allow developing composite materials that fulfill the requirements related to the field of power electronics. However, the anisotropic thermal properties of these reinforcements may generate a strong influence of the reinforcement orientation on the macroscopic thermal properties of the MMC. Moreover, the oxide layer on Al particles inhibits Al-C reactivity. Therefore, the areas of research discussed in this work are: Orientation optimization of anisotropic reinforcements by a microstructural design Development of composite materials with mixed reinforcement (GF+FC) to evaluate the influence of the combination of the two reinforcements on the thermomechanical properties; Elaboration of composite materials by liquid phase sintering in order to optimize the interfacial properties and densification of composite materials with high carbon content.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • SubjectMaterials Science
  • BylineArticles whose byline prints “Jean Francois Silvain”