Scholars Central

Research articlePublished 15 Nov 2017

Inhibiting and Inactivating Effect of Chitosan on Heat Resistant Moulds Responsible for Spoilage of Pasteurized Fruit Products

Authors: Manusia SA, Berni E

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

The antimicrobial properties of chitosan, a deacetylated derivative of chitin, were assessed in a synthetic medium and in a blueberry and red grape juice against six heat resistant moulds (HRM) associated with food spoilage, in order to evaluate its use as a potential food preservative of natural origin. In both synthetic medium and natural substrate, the Minimum Inhibitory Concentration (MIC) of chitosan proved to vary in a wide range, regardless to both fungal genus and medium considered. Although Aspergillus neoglaber, Talaromyces bacillisporus and Aspergillus niger proved most resistant to chitosan (MIC > 5000 mg/L) on both media, a marked difference was detected for other strains tested. On HRM inoculated in MEB, the MIC was equal to 100 mg/L for Byssochlamys fulva or Monascus floridanus, and to 1000 mg/L for Talaromyces macrosporus. On HRM inoculated in blueberry and red grape juice, the MIC was equal to 2500 mg/L for Byssochlamys fulva or Monascus floridanus, and to 5000 mg/L for Talaromyces macrosporus. If combined with thermal treatment (80°C for 5 min) at a concentration (500 mg/L) that did not prove effective in inhibiting fungal spores, chitosan did not affect spore survival of microorganisms tested, thus allowing the spoilage of tested fruit juice after 5 days at 30°C. Also heat resistance parameters of a selected heat-resistant strain, T. bacillisporus, were not significantly affected by supplementation of blueberry and red grape juice with 500 mg/L of chitosan, D values ranging between 47.6 and 71.4 minutes at 82°C; 13.3 and 23.3 minutes at 85°C; 3.6 and 5.9 minutes at 88°C; 0.9 and 1.8 minutes at 91°C (z=5.2°C to 5.5°C). Since chitosan did not prove effective alone or combined with thermal treatment either to inactivate heat resistant microorganisms tested or to modify heat-resistance parameters of a heat resistant mould such as T. bacillisporus, its use cannot be considered as an interesting strategy to apply milder thermal treatments and to achieve stability of acid products.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • BylineArticles whose byline prints “Manusia SA”
  • BylineArticles whose byline prints “Berni E”