Case reportPublished 27 Aug 2013
Stereolithography and the Use of Pre-Adapted / Fabricated Plates for Accurate Repair of Maxillofacial Defects
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
The purpose of this paper was to share our clinical experience on the use of pre-adapted / fabricated plates using stereolithography for accurate repair of maxillofacial defects. We present five cases where pre-adapted / fabricated plates were either used to reconstruct defects following tumour resection or for secondary reconstructions of maxillofacial trauma. Our opinion concerning Stereolithography Models (SMs) is that they probably do not offer the surgeon relevant diagnostics information, but they are very useful in the surgical planning of any maxillofacial operation. SMs allow direct simulation of osteotomies, grafts and the measurement of bone movements. Prefabricated/adapted plates combined with SMs reduce intra-operative time and morbidity, increase accuracy of the surgical reconstruction and minimize complications and surgeons’ stress. However, these technologies are expensive. Therefore, considering their cost, we see indications in secondary corrections of the maxillofacial trauma and tumour reconstruction.
Subjects
Dentistry & Oral HealthAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- SubjectDentistry & Oral Health
- BylineArticles whose byline prints “Jehad Al-Sukhun”
- BylineArticles whose byline prints “Heikki Penttila”