Research articlePublished 2 Jan 2015
Creep of a cast cobalt-based alloy in 3-points flexion and dependence on the applied load
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
A cobalt-based alloy Co-25Cr-0.25C was elaborated by casting. Its microstructure was composed of a dendritic matrix and of interdendritic chromium carbides. Three parallelepiped samples were tested at 1200°C in three-points flexion under a constant load, masses leading to 10, 15 or 20 MPa as maximal stress in the middle of the sample bottom. The two first phases of creep, primary and secondary, were characterized and their dependence on the applied load studied. Laws of dependence of the deformation rate in secondary stage of creep upon the resulting maximal stress similar to what is known for tensile creep, were tried to represent this dependence. In the present case the relationship which is the most suitable is the one which corresponds to the rather low stresses.
Subjects
Materials ScienceAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalMaterials Science: An Indian Journal
- SubjectMaterials Science
- BylineArticles whose byline prints “Lionel Aranda”
- BylineArticles whose byline prints “Thierry Schweitzer”
- BylineArticles whose byline prints “Patrice Berthod”
- BylineArticles whose byline prints “Elodie Conrath”
