Scholars Central

Research articlePublished 1 Sep 2022

Heat Treatment Effect on Microstructural, Mechanical and Tribological Properties of Nickel Aluminium Bronze Alloy Manufactured by Laser Powder-Bed Fusion Technique

Authors: Fathia Alkelae, Shinya Sasaki

Journal of Material Sciences & Engineering

Volume 11 · Issue 3 · Pages 1–8

Ask about this article

Abstract

Select any words in the title or abstract, or press this and choose a sentence.

High density nickel-aluminium bronze alloy (Cu9Al4Fe3Ni) was manufactured using Laser Powder-Bed Fusion Technique (L-PBF), it was investigated regarding the effect of different heat treatment conditions on its mechanical, microstructural and tribological behaviour. Correlations between the microstructures generated (k phases) and the behaviour observed were established. Regardless the heat treatment applied (annealing, tempering, quenching and tempering), friction coefficient, wear loss and hardness have been shown to decrease with increasing heat treatment temperature, while tensile strength and the elongation improved compared to the as-built sample. On the other hand, correlations using increased precipitates content resulting from different heat treatments confirmed the improvement of the material’s mechanical properties at the expense of the tribological ones. A possible interpretation of this results maybe the role of precipitates in impeding dislocations motion leading to increased shear forces, thus deteriorating the embeddability of the soft α phase along with detachment of the hard κ phases allowing a three body abrasive wear to occur. However, in a process similar to strain hardening, hardness and tensile strength are shown to improve with increased precipitation.

Ask about this article

Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. Scholars Central does not store it.

Try:

More from this journal

The newest in Journal of Material Sciences & Engineering.

All its articles

Conferences in this field

Upcoming conferences in this field.

Follow

New articles from what you follow go into your email digest, once you agree to alert emails.

  • JournalJournal of Material Sciences & Engineering
  • SubjectEngineering
  • SubjectMaterials Science
  • BylineArticles whose byline prints “Fathia Alkelae”
  • BylineArticles whose byline prints “Shinya Sasaki”